Toshiba E6581830 instruction manual Overview, Basic specifications

Page 5

E658130

1. Overview

The option allows the VF-S15 drive to be connected into a CC-Link network. CC-Link supports a maximum of 42 nodes, allowing for the Master and this option is based on CC-Link V1.1 and V2.0.

The CCL-003Z is able to operate RUN/STOP, monitor the status of the drive, set the drive’s parameter and etc. by the CC-Link master through installing the VF-S15. And it can use various applications.

2. Basic specifications

<Environmental specification>

Item	Specification
Operating	Indoors, an altitude of 3,000m or less, where the product will not be exposed
environment	to direct sunlight, corrosive or explosive gasses, vapor, coarse particulates
	including dust and where there is no grinding fluid or grinding oil nearby.
Ambient	0 to + 60 degreeC
temperature
Storage	-25 to +65 degreeC
temperature
Related	20 to 93% (no condensation and absence of vapor)
temperature
Vibration	5.9 m/s2 (0.6G) or less (10 – 55Hz)
<CC-Link communication and option specification>
Item	Specification
Number of units	42 units max. (1 station occupied by 1 unit). May be used with other
corrected	equipment.
Baud rate	156k, 625k, 2.5M, 5M, 10Mbps
Power supply	Supplied from SBP009Z
Station type	Remote device station
Number of stations	Ver.1: occupies one station, V2: occupies one station (selectable from among
occupied	double, quadruple and octuple)
Connect cable	CC-Link dedicated cable,
	CC-Link V1.10 compatible CC-Link dedicated cable

- 4 -

Image 5

Contents CCL003Z Introduction Handling in general Table of Contents Overview Basic specificationsCC-Link Ver CC-Link VersionSLD Names and functionsOutline Terminating resistor Installation on inverterConnection cable DA,DB Connection of CC-Link master unit and inverterMaximum connection number of units Page RUN LED indicatorRUN ERR Functions Initial settingC101 Communication parameters for CCL003ZBaud rate setting CC-Link function setting Station number settingCC-Link extended setting Basic functions Run and frequency operation commandMonitor Writing and reading the parameterRAM I/O signal list One station is occupied CC-Link Ver.1 c122=0Quadruple setting is selected CC-Link Ver.2 c122=2 Double setting is selected CC-Link Ver.2 c122=1Octuple setting is selected CC-Link Ver.2 c122=3 Trip history RYnF Instruction code execution request Detail of input and output signals120 On ST = OFF OFF ST = onRemote Register Assignment Instruction code 3 It is the same as instruction code 1 Monitor code RWwn is set Signal Description 00EDH Instruction Codes00FCH 00FDHEx A900 A900H, C123 C123H Details of an error code Fault record display example Reply code Description of reply codeDescription of monitor code Description of output terminal information Description of input terminal informationProgramming examples SW0 SB0RWr0 END Program example for reading the inverter statusX0F Program example for setting the operation mode Program example for setting the running frequency Program example for setting the operation commandsPLS SETProgram example for monitoring the output frequency Program example for parameter writing Program example for parameter reading MOV Program example for trip information readingProgram example for resetting the inverter at inverter error Instructions Unusual diagnosis Option errorDisconnection error of network cable CPU How to check the error using the LEDsTime Line ERR RUN CCL003ZTime Line RUNERR Line RUN Time RUNERR Time RUN Time ERR