Toshiba E6581830 instruction manual Handling in general

Page 3

E658130

Handling in general

Warning

			Do not connect or disconnect a network cable while the drive power is on.
	Prohibited		It may lead to electric shocks or fire.
	Prohibited
			See the instruction manual attached with the option unit for cautions the handling.
	Mandatory		Otherwise, it may lead to electric shocks, fire, injuries or damage to product.
	Mandatory
		Network control


			Warning
			Do not send the value out of the valid range to objects and attributes.
	Prohibited		Otherwise, the motor may suddenly start/stop and that may result in injuries.
	Prohibited
			Use an additional safety device with your system to prevent a serious accident due to the
	Mandatory		network malfunctions. Usage without an additional safety device may cause an accident.
	Mandatory

Caution

Mandatory

Set up “Communication error trip function (see below)” to stop the drive when the option unit is deactivated by an unusual event such as tripping, an operating error, power outage, failure, etc.

-Network Time-Out, drive operation at disconnection, Preset speed operation selection

(Refer to 5.2 for details)

Deactivated the option module may cause an accident, if the “Communication error trip function” is not properly set up.

Make sure that the operation signals are STOP before resetting drive’s fault. The motor may suddenly start and that may result in injuries.

Notes on operation

Notes

When the control power is shut off by the instantaneous power failure, communication will be unavailable for a while.

The Life of EEPROM is approximately 100,000 times. Avoid writing a command more than 100,000 times to the same parameter of the drive and the option module.

- 2 -

Image 3

Contents CCL003Z Introduction Handling in general Table of Contents Overview Basic specificationsCC-Link Ver CC-Link VersionNames and functions OutlineSLD Installation on inverter Connection cableTerminating resistor DA,DB Connection of CC-Link master unit and inverterMaximum connection number of units Page LED indicator RUN ERRRUN Functions Initial settingC101 Communication parameters for CCL003ZBaud rate setting CC-Link function setting Station number settingCC-Link extended setting Writing and reading the parameter Run and frequency operation commandBasic functions MonitorRAM I/O signal list One station is occupied CC-Link Ver.1 c122=0Quadruple setting is selected CC-Link Ver.2 c122=2 Double setting is selected CC-Link Ver.2 c122=1Octuple setting is selected CC-Link Ver.2 c122=3 Trip history RYnF Instruction code execution request Detail of input and output signals120 On ST = OFF OFF ST = onRemote Register Assignment Instruction code 3 It is the same as instruction code 1 Monitor code RWwn is set Signal Description 00FDH Instruction Codes00EDH 00FCHEx A900 A900H, C123 C123H Details of an error code Fault record display example Reply code Description of reply codeDescription of monitor code Description of output terminal information Description of input terminal informationProgramming examples SW0 SB0RWr0 Program example for reading the inverter status X0FEND Program example for setting the operation mode SET Program example for setting the operation commandsProgram example for setting the running frequency PLSProgram example for monitoring the output frequency Program example for parameter writing Program example for parameter reading MOV Program example for trip information readingProgram example for resetting the inverter at inverter error Instructions Option error Disconnection error of network cableUnusual diagnosis CPU How to check the error using the LEDsLine RUN CCL003ZTime Line ERR RUN TimeTime ERR Time RUNERR Line RUN ERR Time RUN