Toshiba E6581830 instruction manual Description of reply code, Reply code

Page 33

E658130

5.5.10.Description of reply code

When executing the frequency setting (RYnD) or instruction code execution (RYnF), check the reply code (RWr (n+2), (n+10), (n+14), (n+16), (n+18)) in the remote register after execution.

Reply code

Data

Item

Description

(Hexadecimal No.)

 

 

0000H

Normal (No error)

Normal completion of instruction code

execution.

 

 

0001H

Write mode error

Parameter write was attempted during operation

other than a stop.

 

 

0002H

Parameter selection

Unregistered code number was set.

error

 

 

0003H

Setting range error

Set data is outside the setting data range.

- 32 -

Image 33
Contents CCL003Z Introduction Handling in general Table of Contents Overview Basic specificationsCC-Link Ver CC-Link VersionNames and functions OutlineSLD Installation on inverter Connection cableTerminating resistor DA,DB Connection of CC-Link master unit and inverterMaximum connection number of units Page LED indicator RUN ERRRUN Functions Initial settingC101 Communication parameters for CCL003ZBaud rate setting CC-Link function setting Station number settingCC-Link extended setting Basic functions Run and frequency operation commandMonitor Writing and reading the parameterRAM I/O signal list One station is occupied CC-Link Ver.1 c122=0Quadruple setting is selected CC-Link Ver.2 c122=2 Double setting is selected CC-Link Ver.2 c122=1Octuple setting is selected CC-Link Ver.2 c122=3 Trip history RYnF Instruction code execution request Detail of input and output signals120 On ST = OFF OFF ST = onRemote Register Assignment Instruction code 3 It is the same as instruction code 1 Monitor code RWwn is set Signal Description 00EDH Instruction Codes00FCH 00FDHEx A900 A900H, C123 C123H Details of an error code Fault record display example Reply code Description of reply codeDescription of monitor code Description of output terminal information Description of input terminal informationProgramming examples SW0 SB0RWr0 Program example for reading the inverter status X0FEND Program example for setting the operation mode Program example for setting the running frequency Program example for setting the operation commandsPLS SETProgram example for monitoring the output frequency Program example for parameter writing Program example for parameter reading MOV Program example for trip information readingProgram example for resetting the inverter at inverter error Instructions Option error Disconnection error of network cableUnusual diagnosis CPU How to check the error using the LEDsTime Line ERR RUN CCL003ZTime Line RUNERR Line RUN Time RUNERR Time RUN Time ERR