Toshiba E6581830 instruction manual Signal Description

Page 28

E658130

	Address	Signal	Description
	RWrn+13	Read data 3	For a normal reply, the reply data to the instruction specified by the
	RWrn+13	Read data 3	instruction code is set.
			instruction code is set.
			When (RYnF) is on, the response code correspond to the instruction
	RWrn+14	Reply code 4	code of (RWw n+14) is set. The value "0" is set for a normal reply and
			other than "0" is set for data fault, mode error, etc.
	RWrn+15	Read data 4	For a normal reply, the reply data to the instruction specified by the
	RWrn+15	Read data 4	instruction code is set.
			instruction code is set.
			When (RYnF) is on, the response code correspond to the instruction
	RWrn+16	Reply code 5	code of (RWw n+16) is set. The value "0" is set for a normal reply and
			other than "0" is set for data fault, mode error, etc.
	RWrn+17	Read data 5	For a normal reply, the reply data to the instruction specified by the
	RWrn+17	Read data 5	instruction code is set.
			instruction code is set.
			When (RYnF) is on, the response code correspond to the instruction
	RWrn+18	Reply code 6	code of (RWw n+18) is set. The value "0" is set for a normal reply and
			other than "0" is set for data fault, mode error, etc.
	RWrn+19	Read data 6	For a normal reply, the reply data to the instruction specified by the
	RWrn+19	Read data 6	instruction code is set.
			instruction code is set.
	RWrn+1A		Do not use it.
	to	Reserved
	RWrn+1F

"n" is depend on the station number.

- 27 -

Image 28

Contents CCL003Z Introduction Handling in general Table of Contents Basic specifications OverviewCC-Link Version CC-Link VerOutline Names and functionsSLD Connection cable Installation on inverterTerminating resistor Connection of CC-Link master unit and inverter DA,DBMaximum connection number of units Page RUN ERR LED indicatorRUN Initial setting FunctionsCommunication parameters for CCL003Z C101CC-Link function setting Station number setting Baud rate settingCC-Link extended setting Run and frequency operation command Basic functionsMonitor Writing and reading the parameterI/O signal list One station is occupied CC-Link Ver.1 c122=0 RAMDouble setting is selected CC-Link Ver.2 c122=1 Quadruple setting is selected CC-Link Ver.2 c122=2Octuple setting is selected CC-Link Ver.2 c122=3 Trip history Detail of input and output signals RYnF Instruction code execution request120 OFF ST = on On ST = OFFRemote Register Assignment Instruction code 3 It is the same as instruction code 1 Monitor code RWwn is set Signal Description Instruction Codes 00EDH00FCH 00FDHEx A900 A900H, C123 C123H Details of an error code Fault record display example Description of reply code Reply codeDescription of monitor code Description of input terminal information Description of output terminal informationProgramming examples SB0 SW0RWr0 X0F Program example for reading the inverter statusEND Program example for setting the operation mode Program example for setting the operation commands Program example for setting the running frequencyPLS SETProgram example for monitoring the output frequency Program example for parameter writing Program example for parameter reading Program example for trip information reading MOVProgram example for resetting the inverter at inverter error Instructions Disconnection error of network cable Option errorUnusual diagnosis How to check the error using the LEDs CPUCCL003Z Time Line ERR RUNTime Line RUNTime RUN ERR Line RUNERR Time RUN Time ERR