Toshiba E6581830 instruction manual Instruction code 3 It is the same as instruction code 1

E658130

Address	Signal	Description
		Set the command code for actions such as operation mode switching,
RWwn+10	Instruction code 2	parameter read, write, error reference, error clear, etc. The command will
		be executed by turning (RynF) on after the register setting is completed.
		When the command execution is completed, (RXnF) turns on.
		Set data specified by the above-mentioned command code 2
RWwn+11	Write data 2	(if necessary). If no data needs to be written, the value shall be zero.
		(RynF) is turned on after setting the above-mentioned command code
		and this register.
RWwn+12	Instruction code 3 It is the same as instruction code 1 and 2.
		Set data specified by the above-mentioned command code 3
RWwn+13	Write data 3	(if necessary). If no data needs to be written, the value shall be zero.
		(RynF) is turned on after setting the above-mentioned command code
		and this register.
RWwn+14	Instruction code 4 It is the same as instruction code 1 and 2.
		Set data specified by the above-mentioned command code 4
RWwn+15	Write data 4	(if necessary). If no data needs to be written, the value shall be zero.
		(RynF) is turned on after setting the above-mentioned command code
		and this register.
RWwn+16	Instruction code 5 It is the same as instruction code 1 and 2.
		Set data specified by the above-mentioned command code 5
RWwn+17	Write data 5	(if necessary). If no data needs to be written, the value shall be zero.
		(RynF) is turned on after setting the above-mentioned command code
		and this register.
RWwn+18	Instruction code 6 It is the same as instruction code 1 and 2.
		Set data specified by the above-mentioned command code 6
RWwn+19	Write data 6	(if necessary). If no data needs to be written, the value shall be zero.
		(RynF) is turned on after setting the above-mentioned command code
		and this register.
RWwn+1A		Reserved
to	Reserved
RWwn+1F

"n" is depend on the station number.

- 25 -