Toshiba E6581830 instruction manual Monitor code RWwn is set

E658130

2. Remote register (Inverter -> Master)

RWr

Address	Signal	Description
RWr n	Monitor value 1	When (RYnC) is on, the monitored value specified to the lower 8 bits of
		the monitor code (RWwn) is set.
		When "0" is set to the higher 8 bits of the monitor code (RWwn), the
	Monitor value 2	current output frequency is always set. When other than "0" is set to the
RWrn+1		upper 8 bits of the monitor code (RWwn) and (RYnC) is on, the
	(output frequency)
		monitored value specified to the higher 8 bits of the monitor code
		(RWwn) is set.
		When (RYnF) is on, the response code correspond to the instruction
RWrn+2	Response code 1	code of (RWwn+2) is set. The value "0" is set for a normal reply and
		other than "0" is set for data fault, mode error, etc.
RWrn+3	Read data 1	For a normal reply, the reply data to the instruction specified by the
		instruction code is set.
RWrn+4	Monitor value 3	When (RYnC) is on, the monitored value specified to the monitor code
		(RWw n+4) is set.
RWrn+5	Monitor value 4	When (RYnC) is on, the monitored value specified to the monitor code
		(RWw n+5) is set.
RWrn+6	Monitor value 5	When (RYnC) is on, the monitored value specified to the monitor code
		(RWw n+6) is set.
RWrn+7	Monitor value 6	When (RYnC) is on, the monitored value specified to the monitor code
		(RWw n+7) is set.
	Trip information	The fault data of the trip history No. specified by (RWw n+8) is stored in
RWrn+8		the lower 8bits.
	(Trip code)
		The trip history No. specified is echo backed to the upper 8bits.
RWrn+9	Trip information	Output frequency of the trip history No. specified in (RWw n+8) is
	(output frequency)	stored.
RWrn+A	Trip information	Output current of the trip history No. specified in (RWw n+8) is stored.
	(output current)
RWrn+B	Trip information	Output voltage of the trip history No. specified in (RWw n+8) is stored.
	(output voltage)
RWrn+C	Trip information	Energization time of the trip history No. specified in (RWw n+8) is
	(energization time)	stored.
RWrn+D		Do not use it.
to	Reserved
RWrn+F
		When (RYnF) is on, the response code correspond to the instruction
RWrn+10	Reply code 2	code of (RWw n+10) is set. The value "0" is set for a normal reply and
		other than "0" is set for data fault, mode error, etc.
RWrn+11	Read data 2	For a normal reply, the reply data to the instruction specified by the
		instruction code is set.
		When (RYnF) is on, the response code correspond to the instruction
RWrn+12	Reply code 3	code of (RWw n+12) is set. The value "0" is set for a normal reply and
		other than "0" is set for data fault, mode error, etc.

- 26 -