Kodak 3H0610, Kodak 10/100 Network Interface Card manual Installing or Removing the NIC

I

N S T A L L A T I O N

NIC Installation and Verification

2.Attach the wrist portion of the antistatic strap to your wrist. Attach the other end of the strap to the metal plate on the electronics drawer on the proofer.

CAUTION: Wear the antistatic strap when you remove the electronics drawer, remove the NIC from the antistatic bag, and remove or install the NIC. This helps prevent static discharge damage to the proofer and the NIC.

3.Remove the three screws that hold the NIC in place. Also, remove the four screws (two on each side) on the back of the proofer holding the electronics drawer with cable connectors in place.

4.Grasp the black handle on the metal plate. Slowly pull the drawer out about six inches.

The proofer is ready. Continue to Section 2.4.

2.4Installing or Removing the NIC

Do as follows to install and seat the NIC.

Note: To remove a NIC, complete these steps in reverse order. On some printers/proofers, you may need to squeeze the standoffs with pliers to remove the NIC.

1. Remove the NIC from its antistatic bag.

2-4 July 1998