Allied Telesis 9103, 9102, 9100, 9101 manual Attaching the Extension Brackets and Rear Brackets

9102/3 Mounting Options Shelf Mounting Options

1.5.2.3 Attaching the Extension Brackets and Rear Brackets

Caution: Two persons are required to mount the 9102/3, with one person in front of and another person behind the unit.

Note that the rear brackets, as shown in Figure 1-8, are rotationally symmetrical; when facing the rear of the unit, the flange is on the bottom on the right, and top on the left. (This allows adequate clearance for removal of the power converter if needed.)

1.The person in front of the unit moves the 9102/3 into position.

2.While the person behind the unit holds the unit steady, the person in front of the unit attaches the unit to the front rack using four mounting screws. (Install the top screws and then the bottom screws.)

3.The person behind the unit attaches the Rear Brackets as shown in Figure 1-8. Adjust the brackets so they are flush with the rear rack. Attach the four nuts loosely since they will move slightly when the rear mounting screws are turned.

4.The person behind the unit attaches the unit to the rear rack using four mounting screws. (Install the top screws and then the bottom screws.). The rear bracket should slide slightly as the screws are tightened.

5.Tighten the four nuts of the Rear Bracket.

FIGURE 1-8Rear Bracket Attachment for 9102/3

Telesyn 9100 Installation Guide (Installation of Allied Telesyn 9100) 1-13