Allied Telesis 9101, 9102, 9103, 9100 manual 9Default Asynchronous Port Settings, Option Default

Page 31

Install Filler Plates (FPF)	Configure Local Terminal or PC

•Carrier Detect

The settings for the CONSOLE port are factory configured with the following default values

Note: When using the CONSOLE port, ensure that the terminal emulation software has FLOW CONTROL disabled.:

TABLE 1-9Default Asynchronous Port Settings

Option	Default	Option	Default

ATTENTION	BREAK	MAXOQLEN	0 (Unrestricted)

CDCONTROL	IGNORE	MTU	1500

DATABITS	8	NAME	ASYN 0

DEFAULTSERVICE	FALSE	OUTFLOW	HARDWARE

DTRCONTROL	ON	PAGE	22

ECHO	ON	PARITY	NONE

FLOW	HARDWARE	PROMPT	DEFAULT (CMD>)

HISTORY	30	SECURE	ON

INFLOW	HARDWARE	SERVICE	NONE

IPADDRESS	NONE	SPEED	9600

IPXNETWORK	NONE	STOPBITS	1

LOGIN	ON	TYPE	VT100

1.Connect the RS-232 cable from the terminal or PC to an RS-232 passthrough device and then to the Allied Telesyn 9100 CONSOLE port.

2.If the device is a PC, bring up the terminal emulation window.

3.Emulation settings are: 9600, 1 STOP, No flow, No parity, 8-bit data

Telesyn 9100 Installation Guide (Installation of Allied Telesyn 9100)

1-27

Image 31

Contents Page Who Should Read This Guide? Reason for UpdateAbout this Guide Table of Contents Appendix Allied Telesyn 9100 Configuration Installation Overview forSelecting a Site for Following Procedures for the 9101, 9102,2Site Requirements for Allied Telesyn 1 9101 Site Requirements3Site Requirements for Allied Telesyn 9102 2 9102/9103 Site Requirements9102/9103 Site Requirements Selecting a Site for 1 9101 Parts Included in Order Setup Checklist4Part Checklist for 5Customer Item Checklist7Part Checklist for 6Part Checklist for2 9102 / 9103 Parts Included in Order Shelf Mounting Options 8Customer Item Checklist1 9101 Mounting Options 4Front mount option for Shelf Mounting Options Center Mounting Option 6Front Mount for 9102/3 2 9102/3 Mounting Options7Mid-Mount for 9102/3 Attaching the Extension Brackets and Rear Brackets Overview Wall Mounting OptionInstalling the Wall Mount Allied Telesyn 9100 Installation SafetySafety Guidelines Electrostatic Discharge Safety Precautions While Working with ElectricityPrecautions and Conformance Standards Laser Safety Instructions Installing Power and Ground forPower and Grounding Cautions Connect Power and Ground Installing Power and Ground for Connect Power and Ground 129100 PEM plug with connections indicated Connect the -48VDC office power supply to the 9101 PEM plugApply and Check Power DC Power Supply Connect to Power Source Single or DualApply and Check Power AC Power Supply Alarm Connections 9101 OptionalInstall the CFC12 Install Card ModulesInstall the SFP Module Install the Service ModuleInstall Filler Plates FPF Configure Local Terminal or PCOption Default 9Default Asynchronous Port SettingsConnect System Cables Service Modules with RJ21connectorsSMs with Optical connectors SMs with RJ45 connectors13.4 GE4/FE2 Data Management Cable Mgmt Port on CFC12 Apply Power and Check Startup Sequence Page Check software load Check the configurationCheck management interfaces Allied Telesyn Contact Information Adding AC Power ModuleGlossary of Terms Appendix1Registration Information for the Telesyn Telesyn 9100 Inventory Form