Allied Telesis 9100, 9102, 9103, 9101 manual Wall Mounting Option, Overview

Page 18

Wall Mounting Option

Overview

1.6 Wall Mounting Option

1.6.1 Overview

If the customer wishes to wall mount the unit, there is a separate kit available through an Allied Telesyn repre- sentative. This kit includes:

•Four brackets that are attached to the unit, two for each side

•Screws for attaching the brackets to the unit.

Refer to Figure 1-9.

FIGURE 1-9Wall Mounting Option

Note: The wall mount kit does not include the screws/bolts that are used to attach the brackets to a wall. The brackets are designed to use M4 or #8 screws, or bolts if appropriate.

1-14Telesyn 9100 Installation Guide (Installation of Allied Telesyn 9100)

Image 18

Contents Page Reason for Update Who Should Read This Guide?About this Guide Table of Contents Appendix Installation Overview for Allied Telesyn 9100 ConfigurationFollowing Procedures for the 9101, 9102, Selecting a Site for1 9101 Site Requirements 2Site Requirements for Allied Telesyn2 9102/9103 Site Requirements 3Site Requirements for Allied Telesyn 91029102/9103 Site Requirements Selecting a Site for 5Customer Item Checklist Setup Checklist4Part Checklist for 1 9101 Parts Included in Order6Part Checklist for 7Part Checklist for2 9102 / 9103 Parts Included in Order 8Customer Item Checklist Shelf Mounting Options1 9101 Mounting Options 4Front mount option for Shelf Mounting Options Center Mounting Option 2 9102/3 Mounting Options 6Front Mount for 9102/37Mid-Mount for 9102/3 Attaching the Extension Brackets and Rear Brackets Wall Mounting Option OverviewAllied Telesyn 9100 Installation Safety Installing the Wall MountSafety Guidelines Safety Precautions While Working with Electricity Electrostatic DischargePrecautions and Conformance Standards Installing Power and Ground for Laser Safety InstructionsPower and Grounding Cautions Connect Power and Ground Installing Power and Ground for Connect Power and Ground Connect the -48VDC office power supply to the 9101 PEM plug 129100 PEM plug with connections indicatedConnect to Power Source Single or Dual Apply and Check Power DC Power SupplyAlarm Connections 9101 Optional Apply and Check Power AC Power SupplyInstall Card Modules Install the CFC12Install the Service Module Install the SFP ModuleConfigure Local Terminal or PC Install Filler Plates FPF9Default Asynchronous Port Settings Option DefaultService Modules with RJ21connectors Connect System CablesSMs with RJ45 connectors SMs with Optical connectors13.4 GE4/FE2 Data Management Cable Mgmt Port on CFC12 Apply Power and Check Startup Sequence Page Check the configuration Check software loadCheck management interfaces Adding AC Power Module Allied Telesyn Contact InformationAppendix Glossary of TermsTelesyn 9100 Inventory Form 1Registration Information for the Telesyn