Canon DR-5060F Cause Optional imprinter’s ink cartridge is not installed, Cause Scanner paper jam

Page 74

Error code

H01

Cause

The optional imprinter’s ink cartridge is not installed.

Remedy

Install the imprinter cartridge.

 

 

Error code

H02

Cause

Endorser (option) connection error

Remedy

Connect the endorser properly.

 

 

Error code

H03

Cause

The imprinter ink cartridge is not mounted, or an endorser

 

connection error has occurred.

Remedy

Attach the ink cartridge or endorser properly.

 

 

Error code

J18

Cause

A document was skewed.

Remedy

Remove the jammed document from the scanner, and check which

 

was the last scanned image.

 

 

Error code

LP

Cause

The lamp has reached the end of its service life.

Remedy

Contact a Canon service department, and replace the lamp.

 

 

Error code

U01

Cause

The number of document sheets to be scanned exceeds the

 

set number of sheets in the verify scan.

Remedy

Two or more sheets may have been fed simultaneously when the

 

number of sheets is counted. Press the Stop key to reset the

 

counter to “0”. Check the number of sheets to see if all document

 

sheets have been counted, and scan the document again.

 

 

Error code

U02

Cause

The number of scanned document sheets is less than the set

 

number of sheets in the verify scan.

Remedy

Two or more sheets may have been fed simultaneously when the

 

document is scanned. Press the Stop key to reset the counter to

 

“0”. Check the number of scanned images with the number of

 

document sheets to see if all document sheets have been correctly

 

scanned, and scan the document again.

 

 

Error codes

P00, P01, P02, P04, P06, P10, P20

Cause

Scanner paper jam

Remedy

Remove the jammed paper. (See “Paper Jam in the Paper Eject

 

Section” P. 61)

 

 

Error code

P30

Cause

Endorser paper jam

Remedy

Remove the paper jammed from inside the endorser according to

 

the Endorser Instructions.

 

 

72When an Error Code is Displayed

Image 74 Contents
Instructions FCC Regulations For 120V models Introduction Filmer This UnitScanner Contents Specifications Options Consumables Chapter TroubleshootingChapter Daily Cleaning Safety Precautions Daily maintenanceSafety Precautions About the Installation Location About the Power Supply CarryingChapter Features of DR-5060F Packaging What’s in the Box? About DR-5060FNames and Functions of Parts Front viewInside with upper unit open Rear viewFunction keys Remaining film indicatorOperation panel Count Only key Backup keySpace/Trailer key New File keyFeeding Option key Indicator lampsStart key Brightness keyFunction key labels Removable trayDocument eject support plate About the Camera Unit Preparation Before Use System Requirements Preparation Before Use Connecting to a ComputerConnecting the Scsi Cable Setting the Scsi ID and Terminator Setting the Scsi IDSetting the terminator Connecting the Power Cord and Ground Cable Connecting the power cordPress the release notch to open the camera unit’s cover Handling the Camera UnitLoading Film Take the microfilm out of its caseClose the left cover taking care not to nip the film Preparation Before Use Affixing the Index Label Close the cover, and make sure that it is lockedLoading the Camera Unit in the DR-5060F Push the camera unit down onto the main unitRemoving the Camera Unit Removing Film Press the release notch to open the cover on the rightRemove the film Store the film in its case Document tray extension Preparing for Paper Feed and EjectAffixing the Document Guide Labels Open the extension wire Document eject tray extensionDocument eject support plate Paper Feed Adjustment To turn this unit ON, press the power switch Turning the Power ON/OFFTurning the Power on Turn the computer onTurning the Power OFF Turn the computer OFF before you turn the scanner OFFPreparing Documents Backup key out Scanner Only mode Checking the Operation ModeBackup key lit Backup mode Backup key blinking Filmer Only modeCount Only mode Count Only key lit Count Only modeWhen counting ends, press the Count Only key to cancel Preparing DocumentsAbout Documents Types of DocumentsDocument Loading Precautions Setting Scan Conditions Selecting the Feeding Option Remote Semi-Auto Is lowered when scanning of all pages in the document endsSemi-Auto Inserted first into the scannerAuto Sensor Manual Insert the document one page at a time To end scanning, press the Stop keyFunction Key Settings Press the blinking function key again Manual Thickness AdjustmentPress the or key to adjust the paper thickness Fixed Thickness Mode Double Feed DetectionFilm Density Restore Memorized SettingImprinter Odometer IndicationSetting in the User Mode User Mode Setup ItemsLeader feed setting Endorser stamp mode settingSpace feed setting Trailer settingWhen the final letter of the user mode setting is a number How to Set the User modeSelect the user mode address using the or key When the final letter of the user mode setting isTroubleshooting When the Scanner is Not Recognized Paper Jam in the Paper Eject Section TroubleshootingRemoving Paper Jams Eject tray extension if it is openPage Paper Jam in the Feed Section Check the intermediate unit for jammed paperPress the open/close button, and lift up the feed unit Remove the jammed paper from the feed sectionGently close the upper unit Removing the Intermediate Unit Attaching the Intermediate Unit Push the intermediate unit downPaper Feed Trouble Condition Paper jam has occurred Condition Double feed cannot be detected Cause Scan conditions are inappropriate When the Scanned Image is Not NormalCause Scanning glasses and rollers on the scanner are dirty Cause Driver or application does not run correctlyWhen an Error Code is Displayed Cause Lamp has reached the end of its service life Cause Optional imprinter’s ink cartridge is not installedCause Endorser option connection error Cause Document was skewedDaily Cleaning Daily Cleaning Cleaning the Main UnitCleaning the Scanning Glasses and Rollers Daily CleaningOpen the feed unit Use a clean, dry cloth to wipe the scanning glasses Lower the lever Press this part Fit into Deeper Two grooves Memo Cleaning the Camera Unit Power CordImprinter Guide Plate Specifications SCSI-IIImprinter Camera unitEndorser ED600 Bar code decoderPage CANON Electronics INC
Related manuals
Manual 92 pages 34.67 Kb