Setup
Recording paper – installing / replacing
For replacement, remove the used core after opening the cover.
1 Open the cover by pressing the cover open button and install the recording paper roll.
Correct |
| Incorrect |
Cover open button
LIf the paper is secured with glue or tape, cut approximately 15 cm from the beginning of the roll.
2 Insert the leading edge of the paper into the opening above the thermal head and pull it out of the unit.
Thermal head
LMake sure that there is no slack in the paper roll.
3 Close the cover securely by pushing down on both sides.
PRESS START
{FAX/START}
4 Press {FAX/START}.
LThe unit will eject the paper slightly and cut it.
LIf you do not press {FAX/START} within 30 seconds, the unit will automatically eject the paper slightly and cut it.
Note:
LOnly use the included roll of paper or specified recording paper, or else the print quality may be affected and/or excessive thermal head wear may occur.
LFor accessory information, see page 13. LWhen the power cord is connected,
every time you close the cover a message will be printed. If the recording paper is set to the wrong side, a massage will not be printed. Install the paper correctly.