Panasonic KX-FC231NZ, KX-FC235AL manual Code #53 Turning SMS ON/OFF KX- FC235AL only

Page 72

10. Programmable Features

“ON” (default): You will hear the friendly reception voice guide, pre-recorded messages and voice time/day stamp.

“OFF”: Deactivates this feature.

Code #53: Turning SMS ON/OFF (KX- FC235AL only)

SMS

=OFF [±]

See page 41 for details.

Code #54: Changing the recording time for your TAM/FAX greeting message

GREETING TIME

=16s [±]

“16s” (default): Maximum recording time is 16 seconds.

“60s”: Maximum recording time is 60 seconds. See page 61 for details.

Code #58: Setting the scan contrast

SCAN CONTRAST

=NORMAL [±]

To send or copy a document with faint or dark writing, set this feature before transmission or copying.

“NORMAL” (default): Used for normal writing.

“LIGHT”: Used for dark writing.

“DARKER”: Used for faint writing.

Code #67: Setting the incoming message monitor

ICM MONITOR

=ON[±]

To hear an incoming message (ICM) from the speaker when the answering device is recording the message.

“ON” (default): You can monitor the incoming message.

“OFF”: Deactivates this feature.

Code #68: Setting the Error Correction Mode (ECM)

ECM SELECTION

=ON[±]

This feature is available when the transmitting/receiving fax machines are ECM compatible.

“ON” (default): If there is an error during fax transmission/reception, the fax machine will support the communication.

“OFF”: Deactivates this feature.

Note:

LYou cannot change the setting when received documents are in memory.

Code #76: Setting the connecting tone

CONNECTING TONE

=ON[±]

If you often have trouble when sending faxes, this feature allows you to hear connecting tones: fax tone, ring back tone and busy tone. You can use these tones to confirm the status of the other party’s machine.

“ON” (default): You will hear connecting tones.

“OFF”: Deactivates this feature.

Note:

LIf the ring back tone continues, the other party’s machine may not be a fax machine or may have run out of paper. Check with the

other party.

LThe connecting tone volume cannot be adjusted.

Code #77: Changing the receiving mode in the auto answer setting

AUTO ANSWER

=TAM/FAX [±]

“TAM/FAX” (default): Telephone Answering Machine/Fax mode (page 55)

“FAX ONLY”: Fax only mode (page 56)

Code #80: Resetting advanced features to their default settings

SET DEFAULT

RESET=NO [±]

To reset the advanced features:

1.Press {MENU}.

2.Press {#}, then {8}{0}.

3.Press {A} or {B} repeatedly to select “YES”.

4.Press {SET}.

5.Press {SET} again.

6.Press {MENU}.

Note:

LThe ECM selection (feature #68 on page 70) will not be reset.

70

Page 71 Page 73
Image 72
Page 71 Page 73
Contents KX-FC231NZ How to use the operating instructions OpenLocation of Controls Base unitHandset Buttons Listed in alphabetical orderAttach your sales receipt here KX-FC235ALKX-FC231NZ TrademarksFor Australian users For New Zealand usersInstallation Service difficultiesImportant information for Australian users Instructions to customerImportant safety instructions Battery For best performance Before calling back Phonebook101 102103 105Included accessories QuantityFor Australian users For New Zealand usersAccessory information Available accessoriesFor Users in New Zealand General Warning Important NoticeButton descriptions of the base unit Button descriptions of the handset Display descriptions of the handset Display iconsDisplay icon Meaning Overview Ink film installation / replacement Installing the ink filmCorrect IncorrectPaper tray Replacing the ink filmRecording paper CorrectIncorrectBattery installation / replacement Installing the batteriesReplacing the batteries Panasonic batteries. See page 11 forConnections Battery charge Battery strengthBattery icons Battery strength Battery lifeTurning the handset power ON/OFF Power onPower OFF Base unit help functionAdjusting handset Adjusting base unit Volume Ringer volumeINT Ring toneDate and time With the handsetExample 315 PM 12-hour time entry Example 10 August, 2005 Press 10 08Your logo With the base unitSET Menu Example 315PM 12-hour time entry 1. Press 03To select characters using a or B Keypad CharactersTo enter your logo Example Bill To change uppercase or lowercase lettersYour fax number Your FAX no Press SETExample +64 9 To delete a numberMaking phone calls Mute Key lockTo turn key lock OFF, press j/OK for about 2 seconds Digital SP-PHONE MuteINT. Any key answer feature Auto talk featureAnswering phone calls Handset phonebookMaking a phone call using the phonebook CategoriesEditing a stored item Erasing stored items One touch dialChain dial Base unit phonebook Erasing a stored itemErase Digital SP-PHONE Caller ID service How Caller ID is displayedAnother method to erase a stored item Category features for Caller ID subscribers Using Caller ID typeChanging category ring tones Viewing and calling back using caller information Caller IDFAX/START Digital SP-PHONE Editing a caller’s telephone number before calling back Erasing caller informationStoring caller information into the phonebook Into the handset phonebookInto the base unit phonebook To erase specific caller information Press Caller IDVoice mail service for Australian users only Call minder for New Zealand users onlySMS Short Message Service Using public mailbox and private mailboxesTurning SMS ON/OFF Changing SMS message centre numbersSending a message Writing and sending a new messageReceiving a message Displaying / Sending a saved messageEditing a saved message Erasing saved messagesDisplaying a received message Erasing received messagesStoring the sender’s number in the handset phonebook Editing the sender’s number before calling backGuide to SMS settings Changing private mailbox settingsStoring the PBX line access number for PBX users only Creating private mailboxesHow to enter characters Available character entries for SMSCharacter entry modes LetterWise character table for EnglishFollowing are used for both uppercase and lowercase Sending a fax manually Stop Redial FAX/START Digital SP-PHONEDocuments you can send Sending a fax using the base unit phonebook Broadcast transmissionProgramming items into the broadcast memory Adding a new item into the broadcast memoryTo cancel broadcast transmission Erasing a stored item from the broadcast memorySending the same document to pre-programmed parties To send the same document to a one-time group of partiesUse only as a fax FAX only mode Selecting the way to use your fax machineAuto receive Use mostly as a telephone TEL mode How to receive phone calls and faxesManual receive Activating TEL mode Receiving a fax manually Auto answerStop FAX/START Digital SP-PHONE Activating TAM/FAX mode TAM/FAX ModeRing setting in TAM/FAX mode Receiving a fax automatically Auto answer onActivating FAX only mode FAX only ModeActivating the junk fax prohibitor Storing undesired callersTo display the junk fax prohibitor list To print the junk fax prohibitor listUsing with the ring detection feature More copying features Making a copyStop Start Setting Recording Original Paper size Document Size DefaultA4, Letter LegalRecording your greeting message Erasing your recorded greeting messageSET MIC Stop Erase GREETING/REC GREETING/CHECK Press GREETING/RECListening to recorded messages Leaving a message for others or yourselfErasing recorded messages SET Stop Erase PlaybackFor voice mail/Call minder service subscribers Remote operation using remote commands Operating from a remote locationSummary of remote operation Turn OFF auto answer setting To turn on the auto answer settingSkip greeting message Recording a marker messageProgramming basic features Programming advanced featuresBase unit programming Basic features Advanced features Code #42 Setting the message alert Code #43 Setting the recording time alertCode #44 Setting the memory reception alert Code #46 Setting friendly receptionCode #58 Setting the scan contrast Code #67 Setting the incoming message monitorCode #68 Setting the Error Correction Mode ECM Code #76 Setting the connecting toneDirect commands for programming features Program code and direct command buttonOFF #76 Connecting tone #80 Set default YES#36 Receiving reduction 72% 86% #39 Display contrastHandset programming Programmable Features Alarm Night modeProgrammable functions Ringer optionsDisplay setup Call options Other optionsProgrammable functions using the base unit PIN Setting pause lengthChanging the recall time Setting call restriction Storing/changing emergency numbersSelecting area codes to be deleted automatically Resetting handset programming that uses the base unit PIN Changing the base unit PIN personal identification numberOperating additional units Registering a handset to a base unitCancelling a handset Cancelling a base unitHandset locator Increasing the range of the base unitExample When handset 1 calls handset Handset Example When handset 1 transfers a call to handset HandsetIntercom between handsets Transferring calls between handsets / Conference callsCopying handset phonebook items Copying a stored itemCopying all stored items Available character entries for the handset LetterWise character table for English KX-FC235AL onlyAlphabet character table ABC Numeric entry table Greek character table M Extended 1 character table N Extended 2 character table OCyrillic character table P Error messages Reports Error messages Base unit display Display Cause and SolutionService personnel Please use genuine Panasonic replacement filmTransmission error occurred. Try again Unnecessary messagesWhen a function does not work, check here Initial settingsGeneral Problem Cause & Solution Speakerphone is not Returns to standby modeProblem Cause & Solution Handset does not Charging but the batteryProblem Cause & Solution Documents usingIs pressed Static, sound cuts in/outFax sending Fax receivingReceiving mode When an extensionDocuments automatically Display showsCopying Answering machineSMS KX-FC235AL only If a power failure occurs When the recording paper has jammed in the unit Recording paper jamsCorrect When the recording paper was not fed into the unit properly START1Document jams sending Document feeder / scanner glass cleaning Do not use paper products, such as paper towels or tissuesThermal head cleaning 104 Reference lists and reports Base unit only Specifications Duplex procedure RF transmission power Approx mW Operating environmentMass Weight Approx g StandardIndex 109 110 111 Sales Department Panasonic Australia Pty. Limited Panasonic New Zealand LimitedManufacturer Panasonic Communications Malaysia Sdn. Bhd Global web site Copyright PFQX2248ZA CM0605DT0
Top Page Image Contents