JVC TDR6 installation and operation guide Cabling the TDEM-6110, LNB Power

Page 21

To cable the Analog Audio terminal block connectors:

1.Press the detent using a screw driver with a maximum width of .15 inch to open the clamp below it.

2.Insert audio cable wire into the clamp.

3.Release the detent. The clamp will close tightly on the inserted wire.

Opening the clamp requires firm pressure. The required pressure may temporarily deflect the rear panel, but will not damage the unit.

NOTE

TAUD-6100The TAUD-6100 four-channel audio module process four MPEG-2 audio streams and provides AC3 audio passthrough.

AUDIO A

AUDIO B

PUSH HERE

AUDIO C

AUDIO D

AES/EBU

TAUD-6100

TAUD-6100 Ports

These four audio ports output unbalanced digital AES/EBU audio on female BNC 75 Ω connectors.

TDEM-6110The TDEM-6110 QPSK demodulator module enables the TDR6 to perform as an SDTV or HDTV IRD with four L-band inputs.

TDEM-6110

LNB A

LNB B

LNB C

LNB D

TDEM-6110 Ports

The LNB 1 through LNB 4 connectors are F-Type, 75 Ω female connectors that accept RF from 950 to 2150 MHz, at power levels between -65 dBm and

-25 dBm.

Cabling the TDEM-6110

LNB ports A through D are used to connect the TDR6 to up to four satellite antenna LNBs. Although each of the four RF inputs can be independently configured, only one port may be active at a time.

The IFL cable loss should not exceed 25 dBm to ensure reliable IRD operation over a broad range of satellite operating parameters and varying weather conditions.

LNB Power

In the default configuration, the TDR6 does not supply DC power to the LNB. However, the TDEM6110 can be configured so that the active LNB IN port outputs LNB DC power at <500 mA DC at either 13V or 18V.

Installing the TDR6

01-0870-401B 01/03

11

Image 21
Contents TDR6 Electric Shock Hazard Contents Chapter Troubleshooting Chapter Configuring the TDR6Appendix F Option Module Overview Appendix G Demodulator Application NotesPreface Using This GuideLocating Information Important InformationFront Panel Navigation Issuing CommandsDisplays RevisionErrors Cartons and Packing MaterialsLCD Display IMQ SAAOVE MitiUse Approved Attachments Only Viii 01-0870-401B 01/03 Overview Overview Overview 01-0870-401B 01/03 Installing the TDR6 AC Power CordsVentilation Power-up Sequence Connecting to a Power SourceBasic TDR6 SD Configuration with No Option Modules Installed TMAC-6125 Ports Connecting to a Remote UnitConnecting to a Network TDEC-6161 Ports Cabling the Analog Audio ConnectorsCabling the TDEM-6110 LNB Power01-0870-401B 01/03 TDR6 Front Panel Front PanelTDR6 DTV Receiver/Decoder Menu Structure LCD Text Formats LCD Display LCD SymbolsData a Menu Qpsk Key Character Displayed Correcting Mistakes Example Command Description Parameters / Response Values DVBQPSK, 8PSK, 16QAM DetailsInputConfigFilter allows you set the PCR filter BER Message No services availableNTSC, PAL, Auto PIDMPEG-2 Value, that does not begin with EID Important Considerations when entering Biss EkeyMAC ControlEIA-232 used to configure the remote portRestoring a User Configuration Restoring a Default ConfigurationSaving a User Configuration Locking the Front PanelSetting the Time Setting the DatePerforming a System Reset Unlocking the Front PanelUsing a Remote Unit Configuring Remote Software ParametersRemote Port Ethernet Port Command TypesBaud 01-0870-401B 01/03 TDR6 HD/SD Back Panel with Remote Designators Informational Remote Commands Response Error Messages Explanation Action RequiredAuto DelayChannelmode LangSource MPEG-2, Atsc MPEG2 Sample RateVOL BissBiss Status Biss ModeDC Autosel DC FilterDmlock DclockEbno LNBHdvd Delay FaultlogclearRolloff 35RCRO, 25RCRO TuneMC Access FP RO, RW MC Access CodeMC Access Unlock MC Config ListPgca Authorization MC Default RestorePgca Mode MC Ethernet IP AddressData Pgca TimeoutHandshake InterfaceVBI VD DelayVBI Control VBI FormatVD Setup VD Mode PAL, NTSC, AutoVD PID VD SubmodeConfiguring the TDR6 ConfigurationQuick Start Selecting a Service Setting Local Date and Time Detailed TDR6 ConfigurationTDR6 Detailed Configuration Procedure Demodulator ConfigurationConfiguring the L-Band Carrier Frequency Qpsk Parameter Front Panel Menu Remote Command01-0870-401B 01/03 Fault Reporting and Monitoring TroubleshootingCurrent Faults Fault HistoryCommand Mnemonics Abbreviation Option Module Fault Descriptors are defined in the following table Viewing the Fault History Log Viewing Current FaultsMinimum E b /N 0 dB Input Status LED Not IlluminatedPerformance Problems FACTORY-CONFIGURABLE Features Technical SpecificationsStandard Features Demodulator a D Default ConfigurationsStandard-Definition Video Decoder High-Definition Video DecoderRemote Control Audio Decoder a FUser Data a B Ethernet Front Panel Access01-0870-401B 01/03 Port Pinouts Fault Relay Port Pin SpecificationsEthernet Port Pin Assignments Signal Signal Definition User Data port Pin Specifications Standard RS232Number Synchronous Asynchronous TMAC-6125 Specifications Port SpecificationsTDEC-6100 Specifications TDEC-6161 SpecificationsTAUD-6100 Specifications LNB Port Specifications TDEM-6110 Specifications01-0870-401B 01/03 PAL Tiernan VBI Data TransmissionTiernan VBI Data Transmission Tiernan Proprietary Closed Captions Tiernan CC Tiernan CC Mode is for Ntsc Format OnlyDVB 422 Expanded Windows, 16-line and 32-line Lines Expanded Windows Field for an Encoded Picture Frame Tiernan Closed Captions Front Panel Commands Front Panel Commands for Encoder ConfigurationVE TCC Remote Commands for Encoder ConfigurationVE Vbipass 32LINES01-0870-401B 01/03 Typical Option Module Option Module OverviewOption Module Overview Demodulator Application Notes Industry Standard LNB FrequenciesDemodulator Tuner SAW Filter Spacing Information RateEb/N0 Definition Output Spectrum WidthMinimum and Maximum Information Rates TransponderDemodulator Low Eb/N0 Alarm Estimating Eb/N0 Using a Spectrum AnalyzerEb/N0 Estimation Algorithm Spectrum AnalyzerDiagnostic Commands Offset = Actual RF Programmed RF Table Top and Rack Mount Installation Instructions Rear Rack Mount Instructions Fuse Rear Rack Bracket Mounting Instructions01-0870-401B 01/03 Index Index