Service Mode
G2 Adjustment
Item is password protected.
Highlight ‘G2 adjust’ with the control disc and press ENTER to con- tinue.
A safety notice will be displayed on the screen as it is necessary to open the top cover to adjust the G2.
ENTER selects the G2 adjustment.
EXIT returns to the Common settings menu. ADJUST returns to the Operational mode.
‘G2 adjustment should be performed by RUNCO personnel, or RUNCO authorized dealers’.
If you are qualified, press ENTER to continue. If not qualified, press EXIT to return to the Common settings menu. Further description of the G2 adjustment is given in the Installation manual.
CRT run in cycle
The CRT run in cycle option can only be activated when memory blocks on an internal # pattern are available. When one or more such blocks are available, a flashing white image (5 sec on, 5 sec off) is generated and that for 5 minutes on the first internal block. In the next 5 minutes, a second internal block will be used to generate the flashing white image. The image will also be shifted in a vertical way to prevent a CRT burn in. To quit the CRT run in cycle option, press EXIT.
Highlight ‘CRT run in cycle’ with the control disc and press ENTER to start.
ENTER selects the CRT run in cycle option. EXIT returns to the Path Selection main menu.
COMMON SETTINGS
G2 ADJUSTMENT CRT RUN IN CYCLE PROJECTOR WARM UP MEMORYBANKS : ON
Select with 
or 
then <ENTER> <EXIT> to return.
COMMON SETTINGS
G2 ADJUSTMENT
CRT RUN IN CYCLE PROJECTOR WARM UP
MEMORYBANKS : ON
Select with 
or 
then <ENTER> <EXIT> to return.
SERVICE MODE
PROJECTOR
COMMON SETTINGS 12C DIAGNOSTICS
Select with 
or 
then <ENTER> <EXIT> to return.