Connection and Startup
LNB supply voltage
If the feed system (LNB) is powered by an external supply voltage and the LNB supply voltage is not used for switching over polarity (e.g. Kathrein feed system UAS 330), the LNB supply of the receiver must be set to "OFF" (see section "Installation menu, LNB configuration").
Modulator connection
If your TV set is not equipped with a SCART socket, you can connect the receiver by means of a coaxial cable. (See "Technical reference" at the end of this User's Guide.)
For this purpose, connect the modulator output of the receiver to the antenna input of the TV set.
The TV set must be preset to UHF channel 38. The modulator of your receiver "transmits" on this channel (factory setting).
Note | Stereo reproduction is not possible in this configuration! And a decoder for |
| cannot be connected! |
To use the receiver together with a video recorder, loop through the receiver signal via the video recorder (antenna input and output). The output channel of the video recorder must be selected such that the receiver signal is not adversely affected and vice versa. Refer to the corresponding information provided in the User's Guide of your video recorder. Also refer to the connection examples at the end of this User's Guide!
TV and video recorder connection
∙Use a SCART cable to connect the satellite receiver (TV SCART) and TV set.
If your TV set is equipped for stereo output, you can receive the sound in stereo via the SCART connection.
∙Also use a SCART cable to connect the satellite receiver (VCR/AUX SCART) and the video recorder.
Audio connection
If you wish to reproduce the sound via a HiFi system, connect a corresponding Cinch cable from the audio Cinch sockets on the receiver to the input sockets on your HiFi system.
If your HiFi system features a digital input or you have a digital Dolby system, you can connect it to the digital output.
Inserting batteries in the remote control
Remove the cover on the battery compartment on the underside of the remote control.
∙Insert the two supplied batteries in the remote control. Ensure correct polarity of the batteries, the + and – markings are indicated inside the battery compartment.
∙Slide the cover back into the casing and lock in position.
Used batteries are special waste! Therefore do not throw batteries into the household waste but rather deposit them at a collection depot for old batteries!
15