OSD On-Screen Displays

Important on-screen displays

The receiver functions are controlled by a microprocessor and extensive software. The following explanations are intended to improve understanding of all procedures and to minimise the risk of mistakes.

TV channel identifier

The channel identifier is displayed for several seconds every time the channel is

changed or by pressing the Obutton.

The I indicates that a channel is received even if no picture can be seen (e.g. radio). The film symbol indicates a TV channel with the selected channel shown next to it and whether video text is received. The current time, start time and end time of the current programme are shown on the next line provided these data are transmitted. The + in the third line stands for the channel selection from the main channel list. If the favourite list is selected, you will see the "apple" symbol at this point. This is followed by the set sound reproduction mode (depending on the direction of the symbolized sound waves, mono left, mono right or stereo can be set, the digit indicates the number of sound channels). The channel title is shown in the box on the right.

Radio channel identifier

The identifier for the set radio channel has the same configuration. A music note at the top left indicates that this is a radio

channel. Programme times and text are displayed only if the corresponding data are transmitted with the signal.

Error message

"Bad or no signal" indicates that there is a fault in the reception system or in the receiver settings or the transponder is not

transmitting. Instead of the I, the channel

identifier shows a satellite antenna together with the message "bad or no signal". Check the SAT-IF connection and the LNB configuration. As an aid, refer to the list of service settings provided at the end of this User's Guide.

TV channel list

Press the ibutton to show the channel list. A + for the main channel list or the "apple" symbol is indicated at the top left. The list can be changed by pressing the button again. Information relating to the received satellites, the polarization, the symbol rate, scrambling, favorite or standard channel and the parental control is provided in the column below the symbol. The column on the left contains information relating to the channel, the

channel provider and whether the channel is normally scrambled. The required channel can be selected with the bar cursor and confirmed by pressing the

Obutton.

Radio channel list

See above. The same applies to the radio channel list.