Kathrein UFD 545 manual Analogue transponder

Page 40

Installation Menu

All new channels are added to the existing channel list.

Under the menu item "Delete TP" you can remove the transponder from the

channel memory by pressing O. You will be requested to confirm that you wish to remove the transponder before it is deleted.

Analogue transponder

In order to set a new analogue channel, you must first select the "analogue" submenu by pressing -+and confirm your selection with O.

Bear in mind that the outdoor unit must be correspondingly set up for a new satellite (see section "LNB configuration").

The frequencies and polarization are listed in SAT 1 video text, on the internet, in the corresponding TV and satellite magazines or our leaflet "Satellite channels and footprints". For cable connections, observe the information provided by the operator.

Now press the -+button to select the required satellite and, using the number buttons, enter the channel name (see section "Notes on operation").

Move the cursor bar by pressing the

oubutton to select all menu items.

Use the number buttons to make the relevant entries or change the entries

with the -+button. Dynamic noise reduction DNR is normally activated.

Press Mtwice to exit the menu and the new channel will be added automatically to the end of the channel list. You will then see the message:

Changes being saved

Please wait

40

Image 40

Contents DVB Satellite Receiver Page Foreword Important informationContents Timer Settings Sound Settings Glossary, Abbreviations Glossary of Technical Terms Safety Information Setting-up location VentilationMoisture, sunlight, heat Mains voltageFront view Controls, Indicators, Displays and ConnectionsRear view Remote control function buttons ChannelSwitching over between Remote Control Command Sets Receiver on the command setButton functions Menu conceptAlphanumeric entries Language selection OSD Presetting of the receiving system Connection and StartupTo connect the receiver Sat-IF connectionInserting batteries in the remote control LNB supply voltageModulator connection TV and video recorder connectionFactory setting of the receiver Switching on for the First TimeFirst steps OSD On-Screen Displays Important on-screen displaysSelecting a TV channel Channel selectionReception status digital Switching over to radio channel Reception status analogueSelecting a radio channel by number entry Timer Settings Sound Settings Setting the volumeStereo and two-channel sound reproduction MuteSelecting TV and radio channels last received Channel Lists TV/radioFavourite channels To sort the channels To delete a channelTo add a channel To add an analogue channel Analogue channel listsTo set up satellites Adding/Removing SatellitesTo enter a satellite name To remove satellitesThis function cannot be selected in analogue mode Current Channel OverviewFactory setting PasswordEntering a password Parental control Operation from the Front Panel Operation in exceptional casesSetting System Parameters Local time/timerSystem parameters Parental controlTimer menu Summer timeTV type Picture formatMod.typ Mod.ChOSD colour OSD-TransInstallation Menu LNB configuration Changing the oscillator frequency Antenna settings Satellite scanTP setup/scan Scan completed Press OK buttonAnalogue transponder DiSEqC UFO setup KHz signalTone burst Preprogramming is not deleted under Reset Analogue Settings Video menuHDP mode Audio modeAudio menu DecoderBandwidth Frequency left/rightDe-emphasis Recording Video Recorder ConnectionPlayback Analogue Decoder Connection Modulator receptionData Transfer from Receiver to Receiver PreparationTransferring channel list Transferring operating softwareTechnical features Technical ReferenceTechnical data HF featuresAccessories Scart socket assignmentsConnection examples Connection arrangementAnalog Glossary, Abbreviations DVBGlossary of Technical Terms DiSEqCSymbol rate Satellite ServiceDiSEqC menu Index DNRIndex Page Page Page Page 998.6252/0800/ZWT/PF Subject to technical modifications