Kathrein UFD 545 manual Adding/Removing Satellites, To set up satellites

Page 27

Adding/Removing Satellites

To set up satellites

New satellites, can, of course, be included in the LNB configuration.

Due to the associated on-screen displays, all settings and editing must be made from a digital channel slot.

For this purpose, you must know the orbital position of the satellites in order to align the antenna (satellite dish). The menu point "antenna settings" in the installation menu can be used as an aid for the purpose of aligning the antenna.

After accessing the main menu Mand the submenu "Installation" – press the

ouand Obuttons (plus password) to select "LNB configuration".

Select this setting with O, you can now enter or select a new satellite.

Bear in mind that your system must be set up accordingly!

In the next step, press o

uto go to, e.g. the entry "User1".

After pressing the -or +buttons, the on- screen display shown opposite appears.

Confirm by pressing O.

You now see the message:

Changes being saved

Please wait

You can now make the entries corresponding to your receiving system at the necessary positions with the buttons o,uand -or +and then exit the

menu by pressing L 3 times. The new satellite data are saved simultaneously.

Use the number buttons on the remote control to make the alphanumeric entries.

Refer to section "Notes on operation" for information on the exact procedure.

27

Image 27

Contents DVB Satellite Receiver Page Important information ForewordContents Timer Settings Sound Settings Glossary, Abbreviations Glossary of Technical Terms Safety Information Mains voltage Setting-up locationVentilation Moisture, sunlight, heatControls, Indicators, Displays and Connections Front viewRear view Channel Remote control function buttonsReceiver on the command set Switching over between Remote Control Command SetsMenu concept Button functionsAlphanumeric entries Language selection OSD Sat-IF connection Presetting of the receiving systemConnection and Startup To connect the receiverTV and video recorder connection Inserting batteries in the remote controlLNB supply voltage Modulator connectionSwitching on for the First Time Factory setting of the receiverFirst steps Important on-screen displays OSD On-Screen DisplaysChannel selection Selecting a TV channelReception status digital Reception status analogue Switching over to radio channelSelecting a radio channel by number entry Timer Settings Mute Sound SettingsSetting the volume Stereo and two-channel sound reproductionChannel Lists TV/radio Selecting TV and radio channels last receivedFavourite channels To delete a channel To sort the channelsTo add a channel Analogue channel lists To add an analogue channelAdding/Removing Satellites To set up satellitesTo remove satellites To enter a satellite nameCurrent Channel Overview This function cannot be selected in analogue modePassword Factory settingEntering a password Parental control Operation in exceptional cases Operation from the Front PanelParental control Setting System ParametersLocal time/timer System parametersPicture format Timer menuSummer time TV typeOSD-Trans Mod.typMod.Ch OSD colourLNB configuration Installation MenuChanging the oscillator frequency Satellite scan Antenna settingsScan completed Press OK button TP setup/scanAnalogue transponder KHz signal DiSEqC UFO setupTone burst Preprogramming is not deleted under Reset Video menu Analogue SettingsDecoder HDP modeAudio mode Audio menuFrequency left/right BandwidthDe-emphasis Video Recorder Connection RecordingPlayback Modulator reception Analogue Decoder ConnectionTransferring operating software Data Transfer from Receiver to ReceiverPreparation Transferring channel listTechnical Reference Technical featuresHF features Technical dataScart socket assignments AccessoriesConnection arrangement Connection examplesAnalog DVB Glossary, AbbreviationsDiSEqC Glossary of Technical TermsSymbol rate Service SatelliteDiSEqC menu DNR IndexIndex Page Page Page Page 998.6252/0800/ZWT/PF Subject to technical modifications