Kathrein UFD 545 manual Preprogramming is not deleted under Reset

Page 43

Installation Menu

UFO micro system as part of the addressing procedure.

The previously allocated address must be deleted if the receiver is to be used with different receiving systems. This can be done in the Reset menu point.

The original factory setting is then allocated to the receiver. It must then be reset to ON. The receiver will then receive a new address from the new system.

The preprogramming is not deleted under "Reset".

Presetting: OFF

Factory setting

Under this menu point, you can reset all the settings to the factory setting by pressing O.

The factory settings need not necessarily correspond to the settings required for your system!

After the reset, it may be necessary to repeat all settings.

43

Image 43

Contents DVB Satellite Receiver Page Important information ForewordContents Timer Settings Sound Settings Glossary, Abbreviations Glossary of Technical Terms Safety Information Mains voltage Setting-up locationVentilation Moisture, sunlight, heatFront view Controls, Indicators, Displays and ConnectionsRear view Channel Remote control function buttonsReceiver on the command set Switching over between Remote Control Command SetsButton functions Menu conceptAlphanumeric entries Language selection OSD Sat-IF connection Presetting of the receiving systemConnection and Startup To connect the receiverTV and video recorder connection Inserting batteries in the remote controlLNB supply voltage Modulator connectionFactory setting of the receiver Switching on for the First TimeFirst steps Important on-screen displays OSD On-Screen DisplaysSelecting a TV channel Channel selectionReception status digital Reception status analogue Switching over to radio channelSelecting a radio channel by number entry Timer Settings Mute Sound SettingsSetting the volume Stereo and two-channel sound reproductionSelecting TV and radio channels last received Channel Lists TV/radioFavourite channels To delete a channel To sort the channelsTo add a channel Analogue channel lists To add an analogue channelAdding/Removing Satellites To set up satellitesTo remove satellites To enter a satellite nameCurrent Channel Overview This function cannot be selected in analogue modeFactory setting PasswordEntering a password Parental control Operation in exceptional cases Operation from the Front PanelParental control Setting System ParametersLocal time/timer System parametersPicture format Timer menuSummer time TV typeOSD-Trans Mod.typMod.Ch OSD colourLNB configuration Installation MenuChanging the oscillator frequency Satellite scan Antenna settingsScan completed Press OK button TP setup/scanAnalogue transponder KHz signal DiSEqC UFO setupTone burst Preprogramming is not deleted under Reset Video menu Analogue SettingsDecoder HDP modeAudio mode Audio menuBandwidth Frequency left/rightDe-emphasis Recording Video Recorder ConnectionPlayback Modulator reception Analogue Decoder ConnectionTransferring operating software Data Transfer from Receiver to ReceiverPreparation Transferring channel listTechnical Reference Technical featuresHF features Technical dataScart socket assignments AccessoriesConnection arrangement Connection examplesAnalog DVB Glossary, AbbreviationsDiSEqC Glossary of Technical TermsSymbol rate Satellite ServiceDiSEqC menu DNR IndexIndex Page Page Page Page 998.6252/0800/ZWT/PF Subject to technical modifications