Kathrein UFD 545 Switching over between Remote Control Command Sets, Receiver on the command set

Switching over between Remote Control Command Sets

	The remote control features 2 command sets, making it possible to operate
	2 receivers independently of each other in one room (not together with a twin
	receiver).
Note	For this purpose, program one receiver on the command set 1 and the second
	receiver on the command set 2.
	∙ Switch on receiver 1 and receiver 2 off with the power switch.
	⇒ Press and hold the Abutton.
	⇒ Enter "901" with the number buttons.
	∙ To adopt the code, press the ebutton to switch receiver 1 to standby and
	then switch off the device at the power switch.
	∙ Switch on receiver 2.
	⇒ Press and hold the Abutton.
	⇒ Enter "902" with the number buttons.
	∙ To adopt the code, press the ebutton to switch receiver 2 to standby and
	then back into operation. Now switch on receiver 1 again.
	⇒ Press and hold the Abutton.
	⇒ Enter "903" with the number buttons.
Note	When carrying out the first two settings, the remote control must be directed at the
	respective receiver (when switched on).
	By pressing the Abutton, you can now switch between the two command sets A
	and B (toggle function) and alternately operate both receivers.
	Command set 1 is always active as the on-delivery setting.
Note	If you are operating only one receiver and the active command set is switched over
	by mistake so that this receiver can no longer be operated, the remote control can
	be easily switched back to command set 1 by following the procedure described
	above.

11