Kathrein UFD 545 Sound Settings, Setting the volume, Stereo and two-channel sound reproduction

Page 22

Sound Settings

All setting options apply to analogue and digital TV modes as well as radio mode.

Setting the volume

Make sure that the volume of the TV set is set to the room volume.

Set the required volume level by pressing

the -+buttons on the remote control of the receiver. A bar indicator with 31 segments is displayed on the screen to show the set volume. The same procedure also applies to analogue reception.

Stereo and two-channel sound reproduction

(for radio and digital TV reception only)

Modulator connection

Stereo sound is not possible if the receiver signal is reproduced via the modulator.

The channel identifier that you can display by pressing the Obutton shows the set sound reproduction. (Depending on the direction of the symbolized sound waves – under the displayed time – mono left, mono right or stereo can be set. The digit indicates the number of transmitted sound channels). The channel title is shown in the box on the right.

Press the s button to call up the menu for sound and language selection. You can now make the required settings, e.g. language selection, provided the corresponding data are contained in the

reception signal. Press the button once again to exit the menu.

Mute

Press the lbutton on the remote control to mute the sound. This symbol l appears on the screen.

Press the l button again to restore the sound. The standard volume display bar is then shown for several seconds.

Although you can change the channel while in mute mode, it will remain muted until this mode is cancelled or you correct the volume.

22

Image 22

Contents DVB Satellite Receiver Page Foreword Important informationContents Timer Settings Sound Settings Glossary, Abbreviations Glossary of Technical Terms Safety Information Moisture, sunlight, heat Setting-up locationVentilation Mains voltageFront view Controls, Indicators, Displays and ConnectionsRear view Remote control function buttons ChannelSwitching over between Remote Control Command Sets Receiver on the command setButton functions Menu conceptAlphanumeric entries Language selection OSD To connect the receiver Presetting of the receiving systemConnection and Startup Sat-IF connectionModulator connection Inserting batteries in the remote controlLNB supply voltage TV and video recorder connectionFactory setting of the receiver Switching on for the First TimeFirst steps OSD On-Screen Displays Important on-screen displaysSelecting a TV channel Channel selectionReception status digital Switching over to radio channel Reception status analogueSelecting a radio channel by number entry Timer Settings Stereo and two-channel sound reproduction Sound SettingsSetting the volume MuteSelecting TV and radio channels last received Channel Lists TV/radioFavourite channels To sort the channels To delete a channelTo add a channel To add an analogue channel Analogue channel listsTo set up satellites Adding/Removing SatellitesTo enter a satellite name To remove satellitesThis function cannot be selected in analogue mode Current Channel OverviewFactory setting PasswordEntering a password Parental control Operation from the Front Panel Operation in exceptional casesSystem parameters Setting System ParametersLocal time/timer Parental controlTV type Timer menuSummer time Picture formatOSD colour Mod.typMod.Ch OSD-TransInstallation Menu LNB configurationChanging the oscillator frequency Antenna settings Satellite scanTP setup/scan Scan completed Press OK buttonAnalogue transponder DiSEqC UFO setup KHz signalTone burst Preprogramming is not deleted under Reset Analogue Settings Video menuAudio menu HDP modeAudio mode DecoderBandwidth Frequency left/rightDe-emphasis Recording Video Recorder ConnectionPlayback Analogue Decoder Connection Modulator receptionTransferring channel list Data Transfer from Receiver to ReceiverPreparation Transferring operating softwareTechnical features Technical ReferenceTechnical data HF featuresAccessories Scart socket assignmentsConnection examples Connection arrangementAnalog Glossary, Abbreviations DVBGlossary of Technical Terms DiSEqCSymbol rate Satellite ServiceDiSEqC menu Index DNRIndex Page Page Page Page 998.6252/0800/ZWT/PF Subject to technical modifications