Toshiba KV-HD01A manual Description of the FRONT/REAR View, Front View

Page 10

2.DESCRIPTION OF THE FRONT/REAR VIEW

2.1Front View

1

22 20

23 21

Hard-disk drive compartment.

This compartment allows you to install a drive for backup purposes or additional storage. Make sure the drive is well secured with the mounting screws in the mobile rack before you put the rack into the compartment. And remember to turn on the power of the compartment by locking it.

1.44 floppy disk drive. This 1.44 floppy disk slot is used for the system software updating and critical images archiving.

Hard disk compartment lock:

To secure a hard disk in place. Unlock this compartment before you remove the hard disk from the slot without turning off the device.

SETUP button:

Press this to enter the main menu. Press again to exit the setup mode. DISPLAY button:

Push this to show the system operation status on the screen. (Please refer to section 3.3 for details)

SEARCH button:

Press this to enter the search mode for accessing recorded video.

RETURN button:

Press to leave the current setup page and return to the previous page.

REV button:

Press this to play a video in the reverse direction at faster or slower speeds than the recorded speed. Each subsequent press of the REV button increases or slows the rate.

9

Image 10
Contents Installation Operating Manual Table of Contents Main Menu SpecificationsLimited Warranty Apendix 4. -- Network ViewingSafety Precautions FCC NoticeManufacturer’s instruction Graphic symbol definitions Symbol Meaning Important Safety InstructionsIndication definitions Meaning Observe the following when installing DisclaimerCopyrights Important PrecautionsDaily or weekly Maintenance Save Original Packing MaterialsProduct Features Product FeaturesProduct Introduction Description of the FRONT/REAR View Front ViewIndicator of Hard Disk Status Indicator of Alarm Recording ModeIndicator of Timer Recording Mode Power IndicatorRear View Terminal Block Connecting with a Multiplexer InstallationConnecting with a Single Camera or a Quad Processor Basic ConnectionRate 6 HR System InformationQuality High Ntsc Size POSUpdating System Software Video format NTSC/PAL selection Basic Operations Configuring Recording SettingsSet up the REC Time Mode when a multiplexer is connected Ntsc SystemManual Recording Recording OperationsPAL System Timer Recording Start ENDREC Enable TIMER---------------------------- SETMain SET REC Timer REC Schedule Start END Timer Main Timer REC EnableExternally triggered Recording Alarm Recording60F/S Place Operation Status Playback OperationsFast Forward/Reverse Slow Forward/Reverse Play Back Picture-by-picturePlay Back Recorded Video from a HDD of the mobile rack Search OperationsFull List Search Time Search Alarm list SearchSearch Full List Alarm List Time Search MM DD Year HH MM SearchSystem GO to Disk Disk Setting Reformat HD 3 Usage Data BackupBackup Operations Main Backup ALL to HDMain Backup Part to HD Total 41 M Ready to GO OK Cancel Alarm Select Main Backup Alarm to HDDisk Setting Reformat HD 3 Usage Save ENTER/SAVE buttonArchive Clips into Floppy Disk Key Lock OperationSave to J0001.JPG Save to J0002.JPG Save to J000N.JPG Main Menu Right/Left buttonsTIME/ Title Time SettingTitle Setting Title StampREC Schedule Start END Record TimerTimer 0600-1600 1200-180060 F/S REC SettingREC Quality Alarm Setting 30SEC, 1 MIN, 5 MIN, 10 MIN, and NON-STOP Communication Comm SettingNET Enable OFF NET Setting SET Main SET RS232 RS232Disk Setting Backup Full Disk REFORMAT/CLEARSystem Flicker ReductionSituation Status HD3Ntsc PAL SpecificationsJpeg General Command Format SetupCommunication Protocol Command Main Category=0x02 Handshake Second Category=0x01 Keys and signalsCommand Types Request Time Second Category=0x02Request State Second Category=0x05 Set Setup Values Second Category=0x04Set Time Second Category=0x02 Description of System StateAppendix 2. -- System Default Slave No Entry for Backup Battery LOWBackup Complete Backup IncompleteSystem Requirements Connecting KV-HD01 to your networkApendix 4. -- Network Viewing KV-HD01APhysical specification for Ethernet Install the browsing software to your PCRJ-45 PIN configuration for Ethernet Open Network ViewerPicture a Picture BPlay List System status indicatorsViewing Image PgUp & PgUpRate Changing The Record & Timer propertiesChanging Record Properties QualityNumber of Saving Save Change the Timer propertiesArchive Images to the computer Abort ExitOpen the Image Viewer Print Viewing a still JPEG-imageQuit StopDigital Video Recorder