Toshiba KV-HD01A manual System, Flicker Reduction

Page 39

5.7 SYSTEM

The SYSTEM PAGE is used for accessing the history of operation status, setting the password, resuming factory default, and determining the menu display background.

MAIN MENU

TIME/ TITLE

RECORD TIMER

RECORD

ALARM

COMMUNICATION

DISK

SYSTEM

GO TO SYSTEM SETTING

LOG :

	SYSTEM PAGE
			: ENTER
	OPERATION LOG		: ENTER
	MENU BACKGND		: OFF
	FLICKER REDUCT		: OFF
	BUZZER		: OFF
	PASSWORD		: SET
	DEFAULT		: LOAD
	MAIN PAGE
	VIEW OPERATION LOG

This log shows the history of the operation status in chronological order. The operation status is described to the right of the time of each entry. There are seven possible entries as detailed below.

ON : The device was powered up. OFF : The device was powered off. REC : Recording Started.

STOP : Recording stopped.

PLAY : Recorded Video was played back. PAUSE : The display was paused.

V-IN :Video input was connected. V-LOSS :Video loss occurred. P-LOSS :Power interruption occurred.

MENU BACKGND :

05/15/01 18:19:32 ON 05/15/01 18:19:32 OFF 05/15/01 18:19:32 REC 05/15/01 18:19:32 STOP 05/15/01 18:19:32 PLAY 05/15/01 18:19:32 PAUSE 05/15/01 18:19:32 V-IN 05/15/01 18:19:32 V-LOSS 05/15/01 18:19:32 P-LOSS

The MENU BACKGND option is used for setting the background display of the menus. ON : Background is blue.

OFF : Background is transparent.

FLICKER REDUCTION :

The FLICKER REDUCTION option is used to eliminate the flickering condition of an image as it occurs during a playback picture by picture. Slight picture degradation may occur when using this feature.

ON : FLICKER REDUCTION is enabled. OFF : FLICKER REDUCTION is disabled.

38

Image 39

Contents Installation Operating Manual Table of Contents Apendix 4. -- Network Viewing SpecificationsLimited Warranty Main MenuFCC Notice Safety PrecautionsManufacturer’s instruction Important Safety Instructions Graphic symbol definitions Symbol MeaningIndication definitions Meaning Disclaimer Observe the following when installingSave Original Packing Materials Important PrecautionsDaily or weekly Maintenance CopyrightsProduct Features Product FeaturesProduct Introduction Front View Description of the FRONT/REAR ViewPower Indicator Indicator of Alarm Recording ModeIndicator of Timer Recording Mode Indicator of Hard Disk StatusRear View Terminal Block Basic Connection InstallationConnecting with a Single Camera or a Quad Processor Connecting with a MultiplexerSize POS System InformationQuality High Ntsc Rate 6 HRUpdating System Software Video format NTSC/PAL selection Ntsc System Configuring Recording SettingsSet up the REC Time Mode when a multiplexer is connected Basic OperationsRecording Operations Manual RecordingPAL System Start END Timer RecordingTimer Main Timer REC Enable TIMER---------------------------- SETMain SET REC Timer REC Schedule Start END REC EnableAlarm Recording Externally triggered Recording60F/S Place Playback Operations Operation StatusFast Forward/Reverse Play Back Picture-by-picture Slow Forward/ReverseSearch Operations Play Back Recorded Video from a HDD of the mobile rackFull List Search Search Alarm list SearchSearch Full List Alarm List Time Search MM DD Year HH MM Time SearchMain Backup ALL to HD Data BackupBackup Operations System GO to Disk Disk Setting Reformat HD 3 UsageSave ENTER/SAVE button Alarm Select Main Backup Alarm to HDDisk Setting Reformat HD 3 Usage Main Backup Part to HD Total 41 M Ready to GO OK CancelKey Lock Operation Archive Clips into Floppy DiskSave to J0001.JPG Save to J0002.JPG Save to J000N.JPG Right/Left buttons Main MenuTitle Stamp Time SettingTitle Setting TIME/ Title0600-1600 1200-1800 Record TimerTimer REC Schedule Start ENDREC Setting 60 F/SREC Quality Alarm Setting 30SEC, 1 MIN, 5 MIN, 10 MIN, and NON-STOP RS232 Comm SettingNET Enable OFF NET Setting SET Main SET RS232 CommunicationBackup Full Disk REFORMAT/CLEAR Disk SettingFlicker Reduction SystemHD3 Situation StatusSpecifications Ntsc PALJpeg Setup General Command FormatCommunication Protocol Request Time Second Category=0x02 Keys and signalsCommand Types Command Main Category=0x02 Handshake Second Category=0x01Description of System State Set Setup Values Second Category=0x04Set Time Second Category=0x02 Request State Second Category=0x05Appendix 2. -- System Default Slave Backup Incomplete Battery LOWBackup Complete No Entry for BackupKV-HD01A Connecting KV-HD01 to your networkApendix 4. -- Network Viewing System RequirementsOpen Network Viewer Install the browsing software to your PCRJ-45 PIN configuration for Ethernet Physical specification for EthernetPicture B Picture aPgUp & PgUp System status indicatorsViewing Image Play ListQuality Changing The Record & Timer propertiesChanging Record Properties RateAbort Exit Change the Timer propertiesArchive Images to the computer Number of Saving SaveOpen the Image Viewer Stop Viewing a still JPEG-imageQuit PrintDigital Video Recorder