Toshiba KV-HD01A manual Product Features, Product Introduction

Page 9

1.PRODUCT FEATURES

1.1Product Introduction

This DVR uses hard disk drives instead of VCR tapes to store digital video images. It enables you to enjoy the extreme flexibility of digital image archiving instead of clumsy tape management, and is absolutely compatible with most multiplexers in the market. Equipped with a wide range of comprehensive features, such as playback picture-by-picture, quick access video recording by time and event, the upgradeable software, the expandable capacities of the hard-disk drive, and much more, the DVR will make your applications far more flexible and effective than ever before. For everyone, this DVR is going to prove the timely substitute for Time-lapse VCR.

1.2 Product Features

Stores video on hard disks instead of VCR tapes.

Maximum 3 Hard Disks capability. (One removable)

Hard disk hot-swapping capability

Pre-alarm image recording

Capable of working with various known multiplexers.

Time-lapse and real-time recording.

Refresh rate up to 60 FPS (50 FPS for PAL).

Image quality selectable at 3 different levels for recording.

Schedule/Manual/Alarm/Continuous recording mode.

Quick search by time, alarm, event, and recording list.

Fast and slow playback of recorded video at various speeds.

Single-frame playback.

On-screen main menu, title and system timer

Password protection.

Critical image archiving through 1.44 MB floppy drive.

Disk-full warning and operation status LEDs.

RS-232 communication port.

Power interruption recovery.

Operation-status record log.

8

Image 9

Contents Installation Operating Manual Table of Contents Limited Warranty SpecificationsMain Menu Apendix 4. -- Network ViewingFCC Notice Safety PrecautionsManufacturer’s instruction Important Safety Instructions Graphic symbol definitions Symbol MeaningIndication definitions Meaning Disclaimer Observe the following when installingDaily or weekly Maintenance Important PrecautionsCopyrights Save Original Packing MaterialsProduct Features Product FeaturesProduct Introduction Front View Description of the FRONT/REAR ViewIndicator of Timer Recording Mode Indicator of Alarm Recording ModeIndicator of Hard Disk Status Power IndicatorRear View Terminal Block Connecting with a Single Camera or a Quad Processor InstallationConnecting with a Multiplexer Basic ConnectionQuality High Ntsc System InformationRate 6 HR Size POSUpdating System Software Video format NTSC/PAL selection Set up the REC Time Mode when a multiplexer is connected Configuring Recording SettingsBasic Operations Ntsc SystemRecording Operations Manual RecordingPAL System Start END Timer RecordingMain SET REC Timer REC Schedule Start END TIMER---------------------------- SETREC Enable Timer Main Timer REC EnableAlarm Recording Externally triggered Recording60F/S Place Playback Operations Operation StatusFast Forward/Reverse Play Back Picture-by-picture Slow Forward/ReverseSearch Operations Play Back Recorded Video from a HDD of the mobile rackFull List Search Search Full List Alarm List Time Search MM DD Year HH MM Alarm list SearchTime Search SearchBackup Operations Data BackupSystem GO to Disk Disk Setting Reformat HD 3 Usage Main Backup ALL to HDDisk Setting Reformat HD 3 Usage Alarm Select Main Backup Alarm to HDMain Backup Part to HD Total 41 M Ready to GO OK Cancel Save ENTER/SAVE buttonKey Lock Operation Archive Clips into Floppy DiskSave to J0001.JPG Save to J0002.JPG Save to J000N.JPG Right/Left buttons Main MenuTitle Setting Time SettingTIME/ Title Title StampTimer Record TimerREC Schedule Start END 0600-1600 1200-1800REC Setting 60 F/SREC Quality Alarm Setting 30SEC, 1 MIN, 5 MIN, 10 MIN, and NON-STOP NET Enable OFF NET Setting SET Main SET RS232 Comm SettingCommunication RS232Backup Full Disk REFORMAT/CLEAR Disk SettingFlicker Reduction SystemHD3 Situation StatusSpecifications Ntsc PALJpeg Setup General Command FormatCommunication Protocol Command Types Keys and signalsCommand Main Category=0x02 Handshake Second Category=0x01 Request Time Second Category=0x02Set Time Second Category=0x02 Set Setup Values Second Category=0x04Request State Second Category=0x05 Description of System StateAppendix 2. -- System Default Slave Backup Complete Battery LOWNo Entry for Backup Backup IncompleteApendix 4. -- Network Viewing Connecting KV-HD01 to your networkSystem Requirements KV-HD01ARJ-45 PIN configuration for Ethernet Install the browsing software to your PCPhysical specification for Ethernet Open Network ViewerPicture B Picture aViewing Image System status indicatorsPlay List PgUp & PgUpChanging Record Properties Changing The Record & Timer propertiesRate QualityArchive Images to the computer Change the Timer propertiesNumber of Saving Save Abort ExitOpen the Image Viewer Quit Viewing a still JPEG-imagePrint StopDigital Video Recorder