Toshiba KV-HD01A manual Terminal Block

2.3 Terminal Block

SW.OUT		GND		ALM.OUT		FULL		GND		REC		ALM.RST		GND		ALM.IN
9	8		7		6		5		4		3		2		1

1.ALM IN: (INPUT)

This is an alarm input, which can be programmed in the menu system to Normally Open or Normally Closed. (Active low, 5V)

2.GND:

Ground Contact.

3.ALM RST: (INPUT)

This terminal connects to an alarm-clear device for clearing the alarm. (Active low, 5V)

4.REC: (INPUT)

This terminal connects an external switch to turn the recording function of the DVR on/off. (Active low, 5V)

5.GND:

Ground Contact.

6.FULL: (OUTPUT)

This terminal sends out the full-disk signal. (Active low, 5V)

7.ALM OUT: (OUTPUT)

This is an alarm output relay. Connect this to an external device like buzzers or lights. (Active low, 5V)

8.GND:

Ground Contact.

9.SW OUT: (OUTPUT)

This terminal, sending out the timing signal (falling/negative) to a multiplexer. Connect this terminal to a multiplexer’s trigger terminal so that the multiplexer can switch to use the same recording speed as the DVR.

12