Pioneer DVJ-X1 Connection to stereo amplifier without DJ mixer, When set to DJ DJ mode

Before Operating (Connections)

3. Connection to stereo amplifier (without DJ mixer)

Stereo amplifier

Connect CD or AUX input connector (do not connect to PHONO input connector)

Accessory audio cable

DVJ-X1

Y	CB PB	CR PR COMPOSITE
NORMAL
DJ
MODE
DIGITAL	AUDIO OUT	VIDEO OUT
OUT
SYNC IN	L	S
AUDIO OUT CONTROL	R	S
		PREVIEW OUT

L

R

4. Connection to component equipped with digital input connector

CD recorder or amplifier with
digital input connector, etc.	DVJ-X1
NORMAL
DJ
MODE
DIGITAL	Y	CB PB	CR PR	COMPOSITE
OUT	NORMAL
	DJ
	MODE
	DIGITAL	AUDIO OUT	VIDEO OUT
Digital signal cable	OUT
	SYNC IN	L		S
	CONTROL	R
				S
			PREVIEW OUT

■Setting the mode select switch (MODE NORMAL/DJ) (rear panel)

When the unit is used normally as a DJ DVD player, the mode select switch should be set to the “DJ” position. If the switch position is changed during playback, playback will stop and after the stop, playback will begin from the beginning of the disc.

When set to DJ (DJ mode):

¶During DVD playback, the digital output connectors produce 2-channel linear PCM digital data, regardless of the selected audio signal format. In addition, subtitles and certain other functions and operations are not supported.

¶During CD playback, the digital connector outputs only audio data without sub-codes. However, the mode is fixed at 44.1 kHz, with the result that some limitations may be experienced in recording or other functions when CD recorders and certain other compo- nents are connected. For details, consult the Operating Instructions for the component to be connected.

¶Some functions may be limited or disabled during DVD playback (☞ P.3, “About DVD playback in DJ mode”).

When set to NORMAL (NORMAL mode):

¶The digital connector outputs digital data including sub-codes, but the player’s DJ functions are disabled (☞ P.11).

¶When a non-supported operation is attempted, the display shows the message “NORMAL”.

¶When power is turned ON, if the mode select switch is set to “NORMAL”, the display shows the message “NORMAL”.

¶If you wish to use all ordinary functions during DVD playback, set the unit to NORMAL mode (☞ P.3, “About DVD playback in DJ mode”).

Note:

Most DJ functions (cue, loop, reloop, tempo adjust, hot cue, jog dial, reverse play) are not supported when the mode select switch is set to “NORMAL”. In addition, the pause mode is silent, not audible.

14

En <DRB1390>