Barco R9001280 owner manual Battery installation in the RCU

Page 12

Unpacking and Dimensions

Battery installation in the RCU.

A battery (not yet installed to save the battery life time) is delivered inside the plastic bag with the power cord. To install the battery, remove the battery cover on the backside of the remote control by pushing the indicated handle a little to the bottom of the RCU. Lift up the top side of the cover at the same time (fig. 1).

Insert the new 9 V battery (type E-block or equivalent) in the lower compartment and connect the battery to the contact plate.

Insert the battery into the lower compartment and put the cover back.

Note : projector address has to be programmed on the RCU before using the RCU (see chapter 'Controlling').

Contact plate

fig.1

Insert here the 'Insert card RCU' which you can cut out on the last page of this manual.

Battery

fig.2

310a.DRW

2-2		5975348 BARCOVISION 8200 210497

Image 12

Contents Vision Page Barco Projection Systems Date Rev Art. No 280497 R5975348Barco nv/Projection Systems Noordlaan Kuurne BelgiumTable of Contents Service Mode Safety Instructions Installation instructionsGeneral safety instructions Mains lead AC Power cord with CEE 7 plugInstructions pour l’installation Remarque sur la SécuritéFédéral communication commission FCC statement Prescriptions de securite généralesOn Installation On CleaningOn Servicing On Repacking’Installation Entretien et RéparationNettoyage Ré-emballageProjector dimensions UnpackingBarcovision Battery installation in the RCU Installation guidelines EnvironmentWhat about ambient light ? Which screen type?Where to install the projector? How to install a projection lens?Definitions of the Abbreviation on drawings Inputs and computer video format input compatibilityLocation and Functions of Control Front panel terminologyControl Panel Terminology Local keypadRemote control TerminologyRCU Installation SET UP System Settings Power mains cord connection Switching onConnections FusesSwitching to stand-by Switching off Input connectionsInput module insertion into the projector Video/S-video input module Straps on module levelRGB analog input module RGB input selectionComponent input module Component input selectionIndication on the input slot menu RGB3S/RG3sB input module Input selectionSet up of the baud rate for communication with a computer Connecting a Rcvds 05 to the projector Connecting a VS05 to the projectorConnecting an IR Remote Receiver 800 to the projector OFF OFF OFF On OFF OFF OFF on OFFHow to use the RCU? Hardware set up of the projector addressControlling Projector addressHow to display a projector address? How to program an address into the RCU?Picture controls with direct access How to control the projector or projectorsHow to get source information? How to get a summary of your projector? Software versionSource SET UP Installation of the settings for a input sourceInput selection Edit file EnterEdit File Options Rename CopyMove DeleteOptions Source Set Up Signal operations Video offsetGain Gain adjustment per color SmoothnessStill video On/Off Sync Fast/SlowScreen operations Zoom/panMoves the window upwards Picture Compresses the picture in the horizontal direction Configure ConversionGeometry Picture Control in Adjustment Mode Service Mode How to activate the password function?Start up of the Service mode 10-1Convergence adjustment of the LCD panels 0000Green focusing Red on green convergenceBlue on green convergence Modify password Reset Lamp Run TimeLamp Run Time History 10-6 Barcovision 8200 Standard Source SET UP Files Standard source set up filesStandard Source Set Up Files Battery Replacement in the RCU Battery replacement in the RCUFocusing the lens Lens Cleaning ProcedureLenses Lenses Source Numbers 90 Source numbers 90Insert Card