Barco R9001280 owner manual Remote control, Terminology, Rcu

Location and Functions of Control

b. Remote control

This remote control includes a battery powered infrared (IR) transmit-
ter that allows the user to control the projector remotely.
This remote control is used for source selection, control, adaptation
and set up. It includes automatic storing of :	Remote Control (RCU)
- picture controls (Brightness, Sharpness...)
- settings

15

Other functions of the remote control are :

-switching between standby and operational mode.

-switching to "pause" (blanked picture, full power for immediate restarting)

-direct access to all connected sources.

-variable adjustment speed : when pushing continuously on the control disk or the picture keys, the adjustment will be executed in an accelerated fashion.

1

14

Local keypad

9	0	STANDBY		EXIT
7	8		ENTER
5	6	TEXT		PAUSE
3	4	SHARPN	TINT	BRIGHTN
1	2	PHASE	COLOR	CONTRAST

15

4

14

13

12

5

10

8

9

7

2

3

4

5

6

7

ADJ			EXIT
			ENTER
STBY	PAUSE	TEXT	FREEZ
	HELP	-	+
	?	PHASE
9	0	-	+
		SHARPNESS
7	8	-	+
			TINT
5	6	-	+
		COLOR
3	4	-	+
		BRIGHTNESS
1	2	-	+
		CONTRAST

32a

13

12

11

10

9

8

Terminology

Back light key : when activated, all keys will be lighted up

1and visible in the dark.

ADJ. : ADJUST key, used to display on line help while in the

2adjustment mode.

Address key (sunk key), to enter the address of the projector

3(between 0 and 9). Press the sunk address key with a pencil, followed by pressing one digit button between 0 and 9.

STBY : stand by button - to start projection when the

4power switch is switched on.

-to switch off the projector without switching off the power switch.

5PAUSE : to stop projection for a short time, press 'PAUSE'. The image disappears but full power is retained for immedi- ate restarting.

6Help : on line help information

7	Digit buttons : direct input selection.
8	Picture controls : use these buttons to obtain the desired
	picture analog level (see also 'Controlling').
9	PHASE : used to remove the instability of the image.

TEXT : when adjusting one of the image, e.g. controls during

10a meeting, the displayed bar scale can be removed by

pressing 'TEXT' key first. To re-display the bar scale on the screen, press 'TEXT' key again. 'TEXT' key only active in operational mode.

FREEZ : press to freeze the projected image.

11

12	ENTER : to start up the adjustment mode or to confirm an
	adjustment or selection in the adjustment mode.
13	EXIT : to leave the adjustment mode or to scroll upwards
	when in the adjustment mode.
14	Control disk (on RCU) or '+' and '-' keys (cursor keys): to
	make menu selections when in the adjustment mode.
	The control disk can move forward, backward, to the right or
	to the left.
	Comparision between control disk movement and the use of
	the cursor keys on the local keypad :
	RCU	=	local keypad
	control disk up	=	'+' key up
	control disk down	=	'-' key down
	control disk to the right	=	'+' key right
	control disk to the left	=	'-' key left

Use the '+' and '-' keys(cursor keys) : to increase or decrease the analog level of the image controls when they are first selected.

RC operating indication : lights up when a button on the

15remote control is pressed. (This is a visual indicator to check the operation of the remote control)

4-2 5975348 BARCOVISION 8200 210497