| English 17 |
Question | Answer |
The specified operating | The specified range is only valid outdoors in open air. Inside your |
range of the baby | house, the operating range is limited by the number and type of walls |
monitor is 150 | and/or ceilings between the parent unit and the baby unit. |
metres/490 feet. Why |
|
does my baby monitor |
|
manage a much smaller |
|
distance than that? |
|
Why can’t I establish a connection? Why is the connection lost every now and then? Why are there sound interruptions?
What happens during a power failure?
The baby unit and the parent unit are probably close to the outer limits of the operating range or there is interference from other 2.4GHz wireless devices.Try a different location, decrease the distance between the units or switch off other 2.4GHz wireless devices. Please note that it takes about 5 seconds each time before a connection between the units is established.
If the parent unit is sufficiently charged, it continues to operate during a power failure. If there are batteries in the baby unit, it also continues to operate during a power failure.
The operating time of the parent unit is supposed to be at least 6 hours. Why is the operating time of my parent unit shorter?
Why do I get interference on the parent unit?
When the parent unit has been charged for the first time, the operating time is shorter because the battery has not reached its full capacity yet.The rechargeable battery only reaches its full capacity after you have charged and discharged it at least four times. After this, the operating time is 6 hours if the automatic screen activation is not activated and 8 hours if the automatic screen activation mode is activated.
The parent unit consumes a lot of energy when the video display is switched on continuously. Activate the automatic screen activation mode to increase the operating time (see chapter ‘Features’, section ‘Automatic screen activation’).
The volume of the parent unit may be set too high, which causes the parent unit to consume a lot of energy. Decrease the volume of the parent unit
Interference may occur when the parent unit is out of range of the baby unit. Interference may also occur if there are too many walls or ceilings between the parent unit and the baby unit or when other 2.4GHz wireless devices are switched on (e.g. microwave, internet). Put the parent unit in a different place, closer to the baby unit, or switch off other wireless devices.
Why does the parent | Interference may occur when the parent unit is out of range of the |
unit make a buzzing | baby unit. Interference may also occur if there are too many walls or |
sound? | ceilings between the parent unit and the baby unit or when other |
| 2.4GHz wireless devices are switched on (e.g. microwave, internet). |
| Put the parent unit in a different place, closer to the baby unit, or |
| switch off other wireless devices. |
| The rechargeable battery of the parent unit may need to be charged. |