EverFocus EPTZ 100 manual Wall mount

Page 13

3.1.3 Wall mount

Wall mount requires the optional bracket EPTZ 100 WLM.

1)Assemble the connector board to the bracket adapter by 3 M4 screws. Follow the red arrow marks at both board and ceiling adapter for correct position.

1

2) Remove the cable cover from the wall bracket.

2

3)Mount the bracket adapter with connector board to the bracket.

4)Mount the bracket to the wall.

5)Plug the dome module in the ceiling adapter. Make sure that position of the camera module connector fits the correct position of the connector board.

6)After plug-in, turn the camera module some degrees clockwise to latch the camera module.

3	4	8
	4

		6

7

5

7)Assemble the cable cover.

8)Use the hex key to fix the camera position with the locking screw.

13	EPTZ100_ma_en_rev03.doc

Image 13

Contents Eptz Weee Safety WarningsTable of Contents Device Setting Camera Optional Accessories FeaturesIntroduction Delivery ScopeAlarm SpecificationsCamera CommunicationPhysical / environment PowerDimensions with ceiling mount adapter DimensionsDimensions with recessed ceiling mount adapter Dimensions wall bracket Eptz 100 WLM Dimension Eptz 100 with wall mount bracket Eptz 100 WLMDimension ceiling pendant bracket Eptz 100 CPM Dimension Eptz 100 with ceiling pendant bracket Eptz 100 CPMMechanical InstallationCeiling mount Recessed ceiling mount Wall mount Ceiling pendant mount Electrical PowerVideo 3 RS-485 3.1 RS-485 installation with EKB 500 keyboard 3.2 RS-485 installation with EverFocus DVR Alarm Baud rate and Protocol Communication Settings2 RS-485 ID address EPTZ100maenrev03.doc Operation in Setup Menu OSD Menu SetupInitial Start 3 RS-485 bus terminationOSD Structure Part Menu StructureControl System info Main menuDisplay Main Setup CAM Title Advanced setting camera setupCamera White BALMotion DET BacklightFocus AutoLens Init Zoom POS InitEND Exposure BrightnessUart Mode RET PKT Enable User PresetReset SpecialScan Level TiltGROUP1 Speed GROUP2GROUP1 Tour ScanPatrol Record PatternPreview DeleteControl MASK1~4 Privacy MaskInitialize General key description Operation with EKB 500 KeyboardOperation outline EKB 500 Operation with Everfocus Protocol EVF-2Preset positions Eptz 100 setup menuAutopan Remote switching of Eptz 100 output relay Preset toursSwitch Alarm Out 1-8 on Switch Alarm Out 1-8 OFF Pattern toursEKB 500 Operation with PELCO-D/P Protocol Patrol Tour ALL Preset TourGroup 1 Tour Group 2 TourSwitch relay OFF CLR + F4 1 Enter Switch Alarm Out Switch relay on F4 1 EnterCOM Port Setting RS-485 Interface Setting Appendix a Basic Settings AT EKB 500 KeyboardDevice Setting Camera EDR / Edvr / Edsr Series Except EDSR100, EDSR100H Appendix B Basic Settings AT Everfocus DVREcor / Paragon Series System I/O Control menuGeneral Malfunction Recovering Communication Settings of Camera ModuleChina Subsidiary Japan Subsidiary Head Office USA Subsidiary European Subsidiary