EverFocus EPTZ 100 manual Communication Settings, Baud rate and Protocol

Page 20

3.3COMMUNICATION SETTINGS

The setup for general RS-485 parameters - protocol type, RS-485 address and baud rate - is done by DIP switches, located at the top of the camera module.

Correct settings are essential for communication with the dome controller.

For correct communication, all 3 parameters - protocol, baud rate and RS-485 ID- have to comply with the PTZ controller settings.

The 120 Ohm termination (DS3) is used at the last dome in the RS-485 bus for avoiding reflections in the RS-485 bus.

Location of DIP switches:

DS3 DS1

DS2

DS1: Protocol and baud rate

DS2: RS-485 ID (address)

DS3: 120 Ohm termination of RS-485 bus

3.3.1 Baud rate and Protocol

The baud rate setting is done by switch 1 and 2 of DS1:

The telemetry protocol setting is done by switch 3, 4 and 5 of DS1:

20

EPTZ100_ma_en_rev03.doc

Image 20
Contents Eptz Safety Warnings WeeeTable of Contents Device Setting Camera Features Optional AccessoriesIntroduction Delivery ScopeSpecifications AlarmCamera CommunicationPower Physical / environmentDimensions with recessed ceiling mount adapter DimensionsDimensions with ceiling mount adapter Dimension Eptz 100 with wall mount bracket Eptz 100 WLM Dimensions wall bracket Eptz 100 WLMDimension Eptz 100 with ceiling pendant bracket Eptz 100 CPM Dimension ceiling pendant bracket Eptz 100 CPMCeiling mount InstallationMechanical Recessed ceiling mount Wall mount Ceiling pendant mount Video PowerElectrical 3 RS-485 3.1 RS-485 installation with EKB 500 keyboard 3.2 RS-485 installation with EverFocus DVR Alarm Communication Settings Baud rate and Protocol2 RS-485 ID address EPTZ100maenrev03.doc OSD Menu Setup Operation in Setup MenuInitial Start 3 RS-485 bus terminationMenu Structure OSD Structure PartControl Display Main menuSystem info Advanced setting camera setup Main Setup CAM TitleCamera White BALBacklight Motion DETFocus AutoZoom POS Init Lens InitEND Exposure BrightnessUser Preset Uart Mode RET PKT EnableReset SpecialScan Tilt LevelGROUP1 Speed GROUP2Patrol Tour ScanGROUP1 Pattern RecordPreview DeleteControl Privacy Mask MASK1~4Initialize Operation with EKB 500 Keyboard General key descriptionEKB 500 Operation with Everfocus Protocol EVF-2 Operation outlineAutopan Eptz 100 setup menuPreset positions Preset tours Remote switching of Eptz 100 output relaySwitch Alarm Out 1-8 on Switch Alarm Out 1-8 OFF Pattern toursEKB 500 Operation with PELCO-D/P Protocol ALL Preset Tour Patrol TourGroup 1 Tour Group 2 TourSwitch relay on F4 1 Enter Switch relay OFF CLR + F4 1 Enter Switch Alarm OutDevice Setting Camera Appendix a Basic Settings AT EKB 500 KeyboardCOM Port Setting RS-485 Interface Setting Appendix B Basic Settings AT Everfocus DVR EDR / Edvr / Edsr Series Except EDSR100, EDSR100HEcor / Paragon Series System I/O Control menuRecovering Communication Settings of Camera Module General MalfunctionHead Office USA Subsidiary European Subsidiary China Subsidiary Japan Subsidiary