EverFocus EPTZ 100 manual Scan

4.1.7 Scan

This menu contains all setup options for automatic dome modes such as autopan, preset tours and pattern.

SCAN

AUTO PAN

ALL PRESET

GROUP SCAN

TOUR SCAN

PATROL

PATTERN

AUTO PAN	PAN/TILT	This autopan mode performs pan and tilt movements between 2
		points. The vertical movement will be processed in programmed
		speed from start / end point, the resulting movement is shown if
		the schema below:

START	Left autopan limit. Move to the position and press
	IRIS - to store the start point.
END	Right autopan limit. Move to the position and press
	IRIS - to store the end point.
SPEED	Autopan speed, range from 2 (slowest) to 180
	(fastest).
DWELL	Dwell time at start and end position, adjustable
	1~45 seconds.
RUN	Autopan start (this function will close OSD menu)
RETURN	Return to AUTO PAN menu.

PAN ONLY This autopan mode performs a horizontal movement between 2 points.

START	Left autopan limit. Move to the position and press
	IRIS - to store the start point.
END	Right autopan limit. Move to the position and press
	IRIS - to store the end point.
SPEED	Autopan speed, range from 2 (slowest) to 180
	(fastest)
DWELL	Dwell time at start and end position, adjustable
	1~45 seconds.
RUN	Autopan start (this function will close OSD menu).

31 EPTZ100_ma_en_rev03.doc