FH-3 Film Holder
The
Placing Film in the Holder
Open the holder |
|
1 Holding the | Nikon logo |
uppermost, unlatch the holder snaps |
|
and open the holder. |
|
| Snap |
Place film in the holder |
|
2 Place a strip of |
|
(matte emulsion surface down) in the |
|
bottom half of holder. Align the frame |
|
to be scanned with an aperture in the |
|
bottom half of the holder. |
|
| Aperture |
Close the holder |
|
3 Close the holder and align the ends of |
|
the top and bottom halves. Latch the |
|
holder cover and snap the top and bot- |
|
tom halves together at both ends. |
|
| Snap shut |
Align the film with an aperture |
|
4 Slide the black plastic holder until the | Apertures |
frame to be scanned is aligned with one |
|
of the two apertures in the metal cover. |
|
“Film Base”/”Emulsion Surface”
When film is examined under bright light, the image on the emulsion surface will be in slight relief, with bumps and hollows where the image has been developed. The opposite surface (the film base) will be reflective and smooth. Place the film in the holder base up.
50