Nikon 5000ED user manual Inserting the Holder

Inserting the Holder

1 Insert the MA-21 slide-mount adapter

After confirming that the status LED is not blinking, slide the MA-21 slide-mount adapter into the adapter slot ( 25). When the adapter is fully inserted, the status LED will blink while the scanner initializes ( 24). Wait until the status LED stops blinking.

2 Insert the FH-3

The direction of insertion depends on which of the two apertures in the metal cover contains the frame to be scanned; refer to the illustration below (arrows indicate direction of insertion). Slide the holder in until it stops.

To scan frames 1–3, insert the left end of the holder into the scanner.

To scan frames 4–6, insert the right end of the holder into the scanner.

Fourth frame scanned (frame “D”).

First frame scanned (frame “A”).

Fifth frame scanned (frame “E”).

Second

frame scanned (frame “B”).

Sixth frame scanned (frame “F”).

Third frame scanned (frame “C”).

Removing the Holder

After confirming that the status LED is not blinking, remove the FH-3 by hand. The eject button on the MA-21 can not be used when removing the FH-3.

Remove Film Holders

Remove the FH-3 after use. Errors may occur if the FH-3 is in place when the scanner is turned on. If an error occurs, turn the scanner off and then on again after removing the FH-3.

51