Toshiba IK-WB21A manual When installing on ceiling, AC adapter cable LAN cable

and Operation

Introduction

Viewing ・ Listening

Recording

Set up

Others

Installing the Camera (Cont.)

Some provided parts are required for installing the camera.

●When installing on ceiling

･Ceiling attachment

･Cover for mounting on ceiling

Important

●Improper installation may cause the camera to fall.

■When installing on ceiling

1 Make a hole in the ceiling where the camera is to be installed to insert the AC adapter cable, LAN cable and other cables.

2 Feed the AC adapter cable, LAN cable and other cables through the hole.

3 Mount the ceiling attachment below the drilled hole.

･Mount on a ceiling or other structure by securely fastening the four corners of the attachment by four wooden screws.

･Install securely on the ceiling where the ceiling is supported by a beam.

･If a beam cannot be found, put a support behind the ceiling to prevent falling of the camera.

･Mount the camera with the lens pointing in the direction of the arrow on the ceiling attachment.

Ceiling Attachment

Groove for passing � the AC adapter cable � and LAN cable.�

�

	Anti-falling stopper
Wood Screw	Anti-falling wire

Important

●Check if the ceiling structure and material have a sufficient strength before installing the camera onto a ceiling. If the amounting strength is inadequate, the camera will fall, potentially causing an injury or a camera failure. The wooden screws supplied as accessories do not provide an adequate strength with some ceiling materials. For example, special anchors are needed if the ceiling material is gypsum boards.

Please consult the building architects regarding ceiling structure and strength.

4 Tie the safety wire of the ceiling attachment onto the safety hook of the camera.

Hook

5 Connect the AC adapter cable, LAN cable and other cables to the terminals on the camera.

AC adapter cable

LAN cable

Introduction
and	Viewing
Operation	Listening
	・
Recording

Set up

Others

18 19