Settings (Step 2 Network Settings)
For setting the motion detection function, which activates the alarm when there is motion in the camera image. Perform the following procedure to set area for motion detection.
1.Start up the
2.Select [Motion Detect] under
1 Select "ON" to turn on the motion detection feature.
2 For setting the time interval for defining a motion.
When there is intensive motion throughout the entire screen, lengthening the time interval will help to prevent false detection.
(Set value: 0 to 3)
3.Perform area setting.
Image of the position that is selected as the Fixed area in 2 of Step 2 will be displayed.
1 Click and drag the mouse to select the detection area. To cancel the detection area (displayed in yellow),
Area for which motion is detected will be displayed in red.
2 For setting the sensitivity level of motion detection.
Drag towards the right to increase and left to decrease the sensitivity level.
Notes
●The area display position only serves as a guide. Ensure to perform operation check.
●Each screen is divided into 300 (20x15) blocks. Adjust the zoom ratio of the lens such that the object for which motion is to be detected is at least the size of multiple blocks.
Cautions
●Flickering lights may cause false detections in motion when the camera is connected.
●When brightness varies due to the use of the auto iris function or lighting conditions, this may be detected as motion. In this case, it is recommended that the detection time be set to a value other than "0".
●Note that the motion detection function is not designed to prevent theft or fire. It may not function properly under certain object or setting conditions. We shall not be responsible for any accident or losses incurred.
38 |
|
|
| 39 |