JVC VN-C205
Alarm Output Function/Set Value, Output Set Values, Output Value, Pattern Level

Settings (Step 2 Network Settings)

2-4 Other Settings Using the "VN-C205U Setup Tool" (4. Alarm Setting) (Continued)

Other Triggers

	Item		Function/Set Value	Initial Value
5 Motion Detection		For setting alarm operations when motion is detected within		—
		the area specified in the motion detection settings.
	• Mode	* Please refer to the [Alarm 1/2] item for details on the set val-		*Please
	• Alarm Output	ues.		refer to
	• Message Packet			the [Alarm
	• Alarm FTP			1/2] item
				for the
				initial
				values.
Alarm Output
	Item		Function/Set Value	Initial Value
6 Output 1/		This section describes the setting procedures for alarm output.		OFF
	Output 2	Set Values	: ON, OFF
	Output Value	Select the alarm output method.		—
		Output OFF : Output alarm signals when the Alarm Output 1
			or Alarm Output 2 terminal is connected to the
			GND terminal.
		Output ON : Output alarm signals when the Alarm Output 1
			or Alarm Output 2 terminal and the GND terminal
			are disconnected from each other.
	Pattern	Level	: Continue output of alarm signals throughout the	—
			alarm input process.
		Momentum : Output alarm signals only at the specified time.
			Specify time using the Return Interval item.
	Interval	For setting the output interval when the Output Pattern item is		—
		set to Momentum.
		This is disabled when the Output Pattern item is set to Level.
7 Output 1		Upon pressing the Output button, alarm signal output will be		—
	force output/	sent from the alarm output terminal on the ceiling mount.
	Output 2	This is used for checking the alarm operation.
	force output	Note

•Output is disabled when the Output Pattern item is set to "Level".

2-4 Other Settings Using the "VN-C205U Setup Tool" (5. Recording Setting)

This function is used to perform settings for local recording, which records camera images to the CF card when the alarm is activated. Please purchase the CF card separately. (☞ Page 19)

●When an alarm is activated, recording can be performed via "local recording", where camera

images are saved into a CF card, or via the V.Networks Controller, where these are saved into the hard disk of the PC. (☞ Page 67)

1.Start up the "VN-C205U Setup Tool" and select [Recording]. To make new values effective, click on [Apply], followed by [OK].

●Setting the [Trigger Recording] screen

1 Select alarm input signal “Trigger” for starting local recording.

44 45