Settings (Step 3 Setting Using the V.Networks Controller)
3-7 Alarm Setting
The "V.Networks Controller" can be used to set the action to be taken when an alarm signal is received.
1.Select [Setting] and [Alarm Setting].
2.Change the set values. (For description of each function, ☞ next page) Setting may be performed for the [Motion Detection], [Alarm 1], [Alarm 2], [Relay Alarm].
1Message
Message entered in the textbox will be displayed when there is an alarm input.
(Up to 100
2Recording
Starts recording when there is an alarm input.
button is pressed.
1 minute : Recording stops after 1 minute.
Notes
●The [1 minute] mode is used for conserving hard disk space.
●In this mode, recording stops after 1 minute even if recording has already started before the alarm input.
3Playing wave file
Plays back a designated Wave file when there is an alarm input. Click the [Browse] button to specify a file.
Note
Alarm actions may be delayed due to PC performance if a large Wave file (.wav) is selected.
4Execute application file
Executes a designated program when there is an alarm input. Click the [Browse] button to specify a program.
1
2
3
4
3.When setting is complete, click 
.
Notes
Alarm Operation
The following settings are required for the operation of the set alarm.
1.[Alarm Reg] is checked. This item is located under the [Setting] menu of the "V. Networks Controller". (☞ Page 57)
2.All alarm settings in the [Alarm Setting] of the
Relay Alarm
When the Relay Alarm function is enabled, subsequent alarms will not be activated.
62 |
|
|
| 63 |