Pull out the cables aside and mount

Preparation (Step 1 Connection/Installation)

1-4 Pull out the cables aside and mount

Settings (Step 2 Network Settings)

2-1 Installing the Software

Plate for depressing cables

Power supply cable

Video signal cable

Wire clamp

1.Follow steps 3 to 6 of mounting the

Camera to the Ceiling (Preparations) (☞ page 16)

2.Pass the input power cable and video signal output cable provided with the camera unit under the plate for depressing cables.

3.Follow steps 1 to 6 of mounting the

Camera to the Ceiling (Installation) (☞ page 20)

4.Bundle all the cables into the wire clamp

Bundle the cables coming out from the ceiling (Video signal cable, Input Power cable, LAN cable and alarm signal cable etc.) into the wire clamp.

5.Follow steps 7 to 8 of mounting the Camera to the Ceiling (Installation)

(☞ page 21)

6.Follow “Mounting the Camera to the

Ceiling (adjustment of the camera’s angle of view)”. (☞ page 23)

To operate this camera, you will have to install the necessary software according to

the following procedure from the CD-ROM supplied.

~~~~~~~~~~~~~~~~~~~

Installing the V.Networks Controller

1.Execute "Setup.exe" in the [JVC] folder.

2.Follow instructions on the screen to install the software.

3.If installation is successful, the † "V.Networks Controller" icon will be displayed in the [Start] †

[Programs] [V. NETWORKS] folder.

Installing the VN-C205U Setup Tool

1.Execute "Setup.exe". This is located inside the [Setup] folder of the [JVC] folder.

2.Follow instructions on the screen to install the software.

3.If installation is successful, the † "VN-C205U Setup Tool" icon will be displayed in the [Start] †

[Programs] [V. NETWORKS] folder.

1-5 White-spot correction

As a general characteristic unique to CCDs, white-spots may appear on the screen with age. In order to reduce this phenomenon, this unit is equipped with a white-spot correction fea- ture.

Switch on the camera power supply and wait for at least 30 minutes.

1. Remove the dome cover.

2. Cover the lens surface using a black sheet of paper, etc. so that light does not enter the lens.

3. Press and hold the SPOT CORRECTION button on the unit for more than 2 seconds.

* White-spot correction will start. Correction may take several seconds for completion.

Notes

•Maximum correction: less than 16 to 32 spots

•The white-spot correction feature of this unit does not guarantee the correction of all white spots. Depending on the characteristic of white spots, correction may not be possible.

•When performing white-spot correction, accurate data may not be achieved in case of highly detailed pixels since correction is made using the information of surrounding pixels.

•The result of white-spot correction is maintained until the next correction is performed.

2627