Chapter 3 | SPAN-CPT Operation |
| |
The offset between the antenna phase center and the IMU navigation center must remain constant and be known accurately. The X, Y and Z positive directions are clearly marked on the SPAN-CPT enclosure. The SETIMUTOANTOFFSET parameters are in metres:
SETIMUTOANTOFFSET x_offset y_offset z_offset [x_stdev] [y_stdev] [z_stdev]
The standard deviation fields are optional and the distances are measured from the IMU navigation center to the antenna phase center.
Y Offset
X Offset
This example assumes a default mounting configuration and shows an -X offset, -Y offset and +Z offset.
A typical RTK GNSS solution is accurate to a few centimetres. For the SPAN-CPT system to have this level of accuracy, the offset must be measured to within a centimetre. Any offset error between the two systems directly affects the output position. For example, a 10 cm error recording this offset will result in at least a 10 cm error in the output.
3.4Real Time Operation
SPAN-CPT operates through the OEM6 command and log interface. Commands and logs specifically related to SPAN-CPT operation are documented in the SPAN on OEM6 Firmware Reference Manual (OM-20000144).
Real time operation notes:
•Inertial data does not start until FINESTEERING time status is reached, and therefore, the SPAN-CPT system does not function unless a GNSS antenna is connected with a clear view of the sky.
•The inertial solution is computed separately from the GNSS solution. The GNSS solution is available from the SPAN-CPT system through the GNSS specific logs even without SPAN running. The integrated GNSS+INS solution is available through special INS logs documented in the SPAN on OEM6 Firmware Reference Manual (OM-20000144).
•The IMU solution is available at the maximum rate of output of the SPAN-CPT (100 Hz). Because of this high data rate, a shorter header format was created. These shorter header logs are defined with an S (RAWIMUSB rather than RAWIMUB). We recommend using these logs instead of the standard header logs to save throughput on the COM port.
Status of the inertial solution can be monitored using the inertial status field in the INS logs, Table 4, Inertial Solution Status on page 27.
26 | SPAN-CPT User Manual Rev 8 |
X
Y
