18.The forward pivots of the step arms (K2 & K3) will arrive with the fixing hardware pre‐installed as depicted in Fig. 4.A. Remove the hardware assembly (parts J1, J2 and J3) from the step arms and set aside.
19.Spacer K1 should remain in place on the pivot axles.
20.Bring the pivots of the left step arm (K3) and handlebar together. Slide the handlebar pivot over the step arm pivot axle and press into place.
21.Thread fixing nut J3 onto the pivot axle and tighten with the provided wrench.
22.Insert hex screw J1 through pivot cap J2 and tighten with the included hex key.
23.Repeat this process for the right side assembly.
12
Fig. 4.A.
Fig 4.B.