Diamondback 500ER manual Pre‐installed on the console mast C as

			500Er Owner’s Manual
		11.	The handlebar pivot fixing hardware will be
			pre‐installed on the console mast (C) as
			shown in Fig. 2. Remove bolt H1 and washer
			H2 from the left and right sides of the pivot
			axle, and set aside.
		12.	Washer I should remain in place, on the
			axle.
Fig. 1.	Fig. 2.	13.	Handlebars (H6 & H7) are packaged with the
			pivot covers (H4) installed. Remove the four
			(4) hex fixing bolts (H5) and pivot cover (H4)
			from each handlebar as shown in Fig. 2. and
			set aside.
		14.	Ensure one piece of washer I is in place on
			each side of the axle as shown in Fig. 3.
		15.	Install the right (H6) and left (H7)
			handlebars by sliding each pivot over the
			axle. Pay careful attention to the alignment
			of the internal spacers as they may block
			the assembly from sliding onto the axle.
			Realign as necessary.
		16.	Fix each handlebar by reinstalling bolt H1
			and washer H2, and tightening with the
			enclosed box wrench.
Fig. 3.		17. Replace the left and right pivot covers (H4)
			by reinstalling the hex bolts H5.
			11