Precor M9.20s Alignment, Running belt, Overtightening the bolt can damage the treadmill

Page 38

Diagram 15	Alignment of the
	running belt

Side platform

Running bed

Rear roller

Belt adjustment bolt

Running belt

2.Locate the left belt adjustment bolt at the rear of the treadmill as shown in Diagram 15. The direction you turn the bolt depends on how the belt is tracking. Make all belt adjustments on the left rear corner bolt using

the hex key (J) provided.

•If the belt is off center to the LEFT, turn the adjusting bolt 1/4 turn clockwise, which moves the running belt to the right.

•If the belt tracks off center to the RIGHT, turn the bolt 1/4 turn counter- clockwise; this moves the belt to the left.

Important: Do not turn the adjusting bolt more than 1/4 turn at a time.

Overtightening the bolt can damage the treadmill.

3.Turn ON the treadmill, answer the start-up prompts, and then increase the running belt speed to 2 miles per hour by pressing the SPEED key.

CAUTION: If you hear a chafing sound or the belt begins to tear or fray, stop the running belt immediately by pressing the STOP key or pulling the magnetic safety key off of the ACTIVATE position. Contact your Precor service representative.

4.Observe the running belt for a couple of minutes. The belt should track centered on the running bed.

5.Press STOP to stop the running belt.

6.If the belt needs additional alignment, repeat steps 1 through 5 of this procedure until the belt is properly aligned.

page 38

Image 38

Contents Low Impact Treadmill Safety Information-Save These Instructions Prevent Electrical ShockPersonal Safety FCC Information Grounding InstructionsDiagram a Proper grounding Plug and power Outlet for ConnectionBefore You Begin Setting Up the M9.20/s Low Impact TreadmillUsing the M9.20/s Low Impact Treadmill Getting the Most Out of Your WorkoutBefore You Begin About this ManualUnpacking the M9.20 or M9.20s Treadmill Hardware kit Setting Up the M9.20/s Low Impact Treadmill Installation RequirementsAssembly Instructions ColumnPlug ConnectorRibbon cable connector Into lowerHandrail InstallUpper ClampHandrail clamp Attach electronicConsole to Attach lower Hex key H providedTo lift column Checking the Alignment of the Running Belt See Aligning the Running BeltM9.20s electronic Using the M9.20/s Low Impact TreadmillUnderstanding the Electronic Console Keys on the Electronic Console MetricStop Ending Your Workout Using the Magnetic Safety KeyPausing Your Workout On the M9.20/s Working Out on Your M9.20/s TreadmillWorking out Calories Using the Manual Course Mode Changing the Interval Course ProfilePage MPH Using the Weight Loss ModePerceived Level of Fitness Speed calculated Changing the Display to U.S. Standard or Metric Speed calculated in KPH Perceived Level of FitnessSelecting the Time or Distance Prompt If you want ThenUsing a Preprogrammed Course on the M9.20s Minute program. Maximizes calorie and fat burn Change your speed and incline as you exerciseAlternating one minute rest and work intervals Each segment equals 0.05 milesPage Creating Custom Courses on the M9.20s Deleting Custom Courses on the M9.20s Improved Getting the Most Out of Your WorkoutMuscles Heart Rate Training Zone How Hard Should I Exercise?How Long Should I Exercise? How Often Should I Exercise?Aligning the Running Belt Cleaning the TreadmillMaintaining the M9.20/s Low Impact Treadmill Overtightening the bolt can damage the treadmill AlignmentRunning belt Adjusting the Tension of the Belt Obtaining Service