Weider 831.14623.0 user manual Cable Assembly, Identify the Butterfly Cable 50. Grease an

24. Apply grease to an M10 x 110mm Bolt (93) and	24
a 90mm Spacer (59). Attach the Left Press Arm
(15) to the Right Press Arm (16) with the Bolt,
the Spacer, and an M10 Nylon Locknut (77).
Finish attaching the Press Arms (15, 16) with
two M10 x 63mm Bolts (79), two M10 Washers
(80), and two M10 Nylon Locknuts (77). Do not
tighten the Nylon Locknuts yet.	16
Apply grease to an M10 x 110mm Bolt (93) and
a 90mm Spacer (59). Attach the Left and Right		77	Grease
Press Arms (15, 16) to the Right Base (1) with
the Bolt, the Spacer, and an M10 Nylon Locknut			59
(77). Do not over tighten the Nylon Locknut;
the Press Arms must pivot freely.					15
	77
Tighten the Nylon Locknuts (77) used in
	Grease		80		93
this step.		59
			77		79
		1
				93	Grease
Cable Assembly	25
25. See the CABLE DIAGRAMS on page 32 and
33 to identify the cables as you assemble
them.			90		Flat Edge
		Grease
Identify the Butterfly Cable (50). Grease an			50
M8 x 22mm Shoulder Bolt (90). Attach the
Cable to the Left Butterfly Bracket (28) with the			78
Shoulder Bolt and an M8 Nylon Locknut (78).			28
Make sure the flat edge of the Cable is
against the Left Butterfly Bracket. Do not
overtighten the Shoulder Bolt; the Cable
must be able to pivot freely.
26. Wrap the Butterfly Cable (50) over a “V”-pulley	26
(47). Attach the “V”-pulley, a Long Cable Trap
(57), an M10 Washer (80), and two Guards (54)
to the Right Upright (2) with an M10 x 63mm
Bolt (79) and an M10 Nylon Locknut (77).			77 54
			47 57
					79
			80	54
			50
		2
	16