Weider 831.14623.0 user manual Make sure the Half Guards are oriented as Shown, Locknut

42. Route the Press Cable (133) under a 90mm		42
	Pulley (48). Attach the Pulley and a Cable Trap
				122		107
	(56) to the Left Frame (122) with an M10 x
	116mm Bolt (107), two Half Guards (55), an			133
	M10 Washer (80), and an M10 Nylon Locknut						55
	(77). Make sure the Cable Trap and the Half					56
	Guards are oriented as shown.
				80		48
				55
			77
43. Route the Press Cable (133) under a 90mm		43
	Pulley (48). Attach the Pulley to the Left Base
	(119) with an M10 x 50mm Bolt (97), two Half
	Guards (55), and an M10 Nylon Locknut (77).
	Make sure the Half Guards are oriented as
	shown.
				48		97
				55	55
				77
						133
					119
44.	Attach the Press Cable (133) to the “U”-bracket	44
	(151) with an M8 Washer (103) and an M8
	Nylon Locknut (78). See the inset drawing. Do
	not completely tighten the Nylon Locknut; it
	should be tightened so that only two					78
	threads of the Cable show past the Nylon		151
	Locknut.					103
				151
			78		133
		133
45. Identify the Leg Lever Cable (51). Route the		45		12			2
	Cable through the Leg Lever (12) and the Front					Bar
			48
	Leg (10), under the indicated bar, and through
	the Right Upright (2).
	Insert a 90mm Pulley (48) into the Leg Lever		85	80
	(12) from the indicated direction. Attach the
	Pulley to the Leg Lever with an M10 x 68mm		109
	Bolt (85), two M10 Washers (80), two 13mm		51 109
	Steel Spacers (109), and an M10 Nylon					10
	Locknut (77).
				80	77
		21