Weider 831.14623.0 user manual Guards are oriented as shown

46. Insert a 90mm Pulley (48) into the Front Leg	46
(10) from the indicated direction. Attach the
		48
Pulley to the Front Leg with an M10 x 68mm
Bolt (85), two M10 Washers (80), two 13mm		51
Steel Spacers (109) and an M10 Nylon Locknut	85 80
(77).
	109
	10
		109 80	77
47. Route the Leg Lever Cable (51) under the indi-	47
cated bars on the Right Base (1). Then, wrap
the Cable under a 90mm Pulley (48). Attach the	55 51
Pulley to the Right Base with an M10 x 50mm
		48
Bolt (97), two Half Guards (55), and an M10	97
Nylon Locknut (77). Make sure the Half		55
Guards are oriented as shown.	Bar		77
	1
48. Wrap the Leg Lever Cable (51) over a 90mm	48
Pulley (48). Attach the Pulley, a Cable Trap
(56), and two Half Guards (55) to the second
hole from the bottom of the Pulley Plates (60)	77
with an M10 x 50mm Bolt (97) and an M10
Nylon Locknut (77). Make sure the Cable Trap	55
and the Half Guards are oriented as shown.	60
	56
	48	55 97
	51
49. Wrap the Leg Lever Cable (51) under a 90mm	49
Pulley (48). Attach the Pulley to the Right Base
(1) with an M10 x 50mm Bolt (97), two Half	51
Guards (55), and an M10 Nylon Locknut (77).	48
Make sure the Half Guards are oriented as
shown.	97
		55
	55
	1	77
	22