Maytag W10201177B manual Dryer Care, Cleaning the Dryer Location, Cleaning the Lint Screen

3.Put the wet items on top of the drying rack. Leave space between the items so air can reach all the surfaces.

NOTE: Do not allow items to hang over the edge of the drying rack.

4.Close the door.

5.Press the POWER/CANCEL button.

6.Select a Timed Dry cycle and temperature (see following chart). Items containing foam, rubber, or plastic must be dried on a clothesline or by using the Air Fluff temperature setting.

7.You must select a time by pressing TIME ADJUST + (plus) or – (minus). Reset time as needed to complete drying. Refer to the following table.

8.Press START/PAUSE.

This chart shows examples of items that can be rack dried and the suggested cycle, temperature setting, and drying time. Actual drying time will depend on the amount of moisture items hold.

Rack Dry	Setting	Temp.	Time*
			(minutes)
Wool Sweaters	Timed Dry	Low	60
Block to shape and lay flat on the drying rack.
Stuffed toys or pillows	Timed Dry	Low	60
Cotton or polyester fiber filled
Stuffed toys or pillows	Timed Dry	Air Fluff	90
Foam rubber filled		(no heat)
Sneakers or canvas shoes	Timed Dry	Air Fluff	90
		(no heat)

*Reset time to complete drying, if needed.

DRYER CARE

Cleaning the Dryer Location

Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air.

Cleaning the Lint Screen

Clean the lint screen before each load. The control panel has an indicator light to remind you to clean the lint screen before each load. A screen blocked by lint can increase drying time.

IMPORTANT:

■Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics.

■If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint.

Every load cleaning

1.The lint screen is located in the door opening of the dryer. Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.

2.Push the lint screen firmly back into place.

23