Maytag W10201177B manual Installation Clearances, Mobile home Additional installation requirements

Page 6

Do not operate your dryer at temperatures below 45ºF (7ºC). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. Drying times can be extended.

The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.

Companion appliance spacing should also be considered.

Additional spacing is required if you exhaust out the rear of the dryer to either the right or left side.

Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes or sleeping quarters. Contact your local building inspector.

Installation Clearances

The location must be large enough to allow the dryer door to open fully.

Dryer Dimensions

43½"

(1105 mm)

 

 

 

 

14" max.*

48 in. 2 *

 

 

 

 

(356mm)

18"*

 

 

 

 

 

(310 cm) 2

 

 

 

 

 

 

(457 mm)

 

 

 

 

 

 

 

 

 

 

 

 

24 in.2 *

 

 

 

 

 

 

(155 cm) 2

1"

29"

1"

1"*

29¼"

5"

 

(25 mm)

(737 mm)

(25 mm)

(25 mm) (743 mm) (127 mm)

 

A

 

 

B

 

 

3"* (76 mm)

3"* (76 mm)

C

 

22¼"

*29¼"

(565 mm)

(743 mm)

29"

 

 

(737 mm)

*Most installations require a minimum 5" (127 mm) clearance behind the dryer for the exhaust vent with elbow. See “Venting Requirements.”

Installation spacing for recessed area or closet installation

The following spacing dimensions are recommended for this dryer. This dryer has been tested for spacing of 0" (0 mm) clearance on the sides and rear. Recommended spacing should be considered for the following reasons:

Additional spacing should be considered for ease of installation and servicing.

Additional clearances might be required for wall, door and floor moldings.

Additional spacing should be considered on all sides of the dryer to reduce noise transfer.

For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable.

A. Recessed area

B. Side view - closet or confined area

C. Closet door with vents

*Required spacing

Mobile home - Additional installation requirements

This dryer is suitable for mobile home installations. The installation must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280) or Standard CAN/CSA-Z240 MH.

Mobile home installations require:

Metal exhaust system hardware, which is available for purchase from your dealer.

Mobile Home Installation Kit Part Number 346764. See “Tools and Parts” section for information on ordering.

Special provisions must be made in mobile homes to introduce outside air into the dryer. The opening (such as a nearby window) should be at least twice as large as the dryer exhaust opening.

6

Image 6
Contents Guide D’UTILISATION ET D’ENTRETIEN W10201177BTable of Contents Table DES MatièresDryer Safety Your safety and the safety of others are very importantPage Installation Instructions Tools and PartsLocation Requirements Mobile home installations require Installation ClearancesMobile home Additional installation requirements Dryer DimensionsGas Type Electrical RequirementsGas Supply Requirements Gas Supply LineBurner Input Requirements Venting RequirementsGas supply connection requirements Dryer Gas PipeIf using an existing vent system If this is a new vent system Vent materialOptional exhaust installations Plan Vent SystemVent system chart Install Vent SystemInstall Leveling Legs Special provisions for mobile home installationsMake Gas Connection Connect VentFor mobile home use Connect Inlet Hose Level DryerRemove the door assembly Reverse Door SwingReverse the strike Reinstall the door Complete Installation If the dryer will not start, check the followingDryer USE Starting Your DryerTo stop or pause your dryer at any time Stopping, Pausing, or RestartingDrying and Cycle Tips To restart the dryerStatus Lights CyclesTimed Preset Cycle Settings Sensor Preset Cycle SettingsSteam Preset Cycle Settings DelicateModifiers OptionsEnd Signal Changing Cycles, Modifiers, and OptionsDrying Rack Option Every load cleaning Cleaning the Dryer LocationCleaning the Lint Screen Dryer CareWater Inlet Hoses Cleaning the Dryer InteriorRemoving Accumulated Lint Vacation, Storage, and Moving CareTroubleshooting Dryer OperationIs the exhaust vent the correct length? Dryer ResultsAre fabric softener sheets blocking the grille? Is the dryer located in a closet?Stains on load or drum Cycle time too shortLint on load Loads are wrinkledU.S.A Assistance or ServiceAccessories CanadaMaytag Major Appliance Warranty This limited warranty does not coverSécurité DE LA Sécheuse Votre sécurité et celle des autres est très importantePage Importantes Instructions DE Sécurité Instructions D’INSTALLATION Exigences d’emplacementOutillage et pièces Dimensions de la sécheuse Linstallation dans une maison mobile exigeDégagements de séparation à respecter Type de gaz Spécifications électriquesAlimentation en gaz Gaz naturelCaractéristiques d’alimentation du brûleur Canalisation d’arrivée de gazExigences concernant le raccordement au gaz Canalisation d’arrivée de gaz de la sécheuseExigences concernant lévacuation En cas dutilisation du système dévacuation existantInstallations dévacuation facultatives ÉvacuationDéterminer litinéraire dacheminement du conduit Raccordement au gaz Installation du système d’évacuationInstallation des pieds de nivellement Pour utilisation dans une maison mobileRaccordement du conduit d’évacuation Raccordement des tuyaux dalimentationRéglage de laplomb de la sécheuse Inversion du sens douverture de la porteDépose de la porte Réinstallation de la porte Inversion de la gâcheFermer la porte vérifier l’engagement de la gâche Achever linstallation Si la sécheuse ne démarre pas, vérifier ce qui suitUtilisation DE LA Sécheuse Mise en marche de la sécheuseUtilisation dun programme minuté Utilisation dun programme de détectionFonctionnement du système de séchage Sensi-Care Utilisation d’un programme vapeurArrêt, pause ou remise en marche Conseils pour le séchage et les programmesTémoins lumineux Programmes Modificateurs Signal de fin de programme Changement des programmes après avoir appuyé sur Start Changement des programmes, modificateurs Et optionsOption de grille de séchage Modification des préréglages de degré de séchageNettoyage du filtre à charpie Nettoyage de lemplacement de la sécheuseEntretien DE LA Sécheuse Jouets rembourrés ou oreillersNettoyage de l’intérieur de la sécheuse Retrait de la charpie accumuléeTuyaux darrivée deau Dépannage Changement de l’ampoule d’éclairage Du tambourFonctionnement de la sécheuse Résultats de la sécheuse La sécheuse affiche un message codéTaches sur la charge ou sur le tambour Temps de programme trop courtCharpie sur la charge Charges avec faux plisAu Canada Assistance OU ServiceAccessoires Si vous avez besoin de pièces de rechangeGarantie DES Gros Appareils Ménagers Maytag La présente garantie limitée ne couvre pasW10201177B