Appendix A: DeviceNet™ Slave Communication
Configure the RSNetWorx for DeviceNet Software
RSNetWorx for DeviceNet is used to set up and manage a DeviceNet network. To begin the configuration, launch RSNetWorx for DeviceNet from your development PC.
Start a new network by selecting: File>New>DeviceNet Configuration.
Register the EDS file generated by Gateway as shown in the previous section of this document by selecting: Tools>EDS Wizard>Register an EDS file(s).
Make sure that the .EDS file validation is successful.
FIG. 40: EDS Validation
If desired, select a new image file to represent the Gate- way.
FIG. 38: Register the EDS File
Select Register a single file, and browse to the location where you saved the Gateway.EDS file.
FIG. 41: EDS Image File
FIG. 39: Browse to Graco Gateway EDS File
52 | 312785C |